Notes:
•You cannot turn off all banks. There must be at least one active bank.
•You can manually select any channel in a bank, even if the bank is turned off.
To turn on banks while scanning, press the number key until the bank’s number appears.
MANUALLY TUNING A FREQUENCY
If desired, you can locate a frequency manually.
To tune to the frequency, follow these steps:
1.Press TUNE.
2.Use the number keys to enter the frequency.
3.Press ENTER.
4.Press 
to move up one tuning step. Press 
to move down one tuning step. To move up or down in 1 MHz increments, press FUNC then press 
or 
. To save the frequency into a channel (bank 9 only), press FUNC then press ENTER. Stored @ 9xx appears on the display (xx: channel number).
When the scanner stops on a frequency while searching, press FUNC then press TUNE. Press 
or 
to tune the frequency.
Notes:
•The
•You can change the receiving mode in the tune mode.
45