BUTTONS PRESSED
CHARACTERS ENTERED
BUTTONS PRESSED
CHARACTERS ENTERED
CLEAR
Back Space
FINDING AND STORING ACTIVE FREQUENCIES
You can search for transmissions in the scanner’s preprogrammed search bank. The search bank is divided into six search bands. You can change the search range of Bank SR5 manually by setting the lower and high- er ends of the search range.
Notes:
•You can use the scanner's delay feature while searching the search bank. See “Using the Delay Function” on Page 26.
•The scanner does not search
Searching a Preprogrammed Fre- quency Range
The scanner contains these preprogrammed search ranges, stored in the search bank (SR0 – SR5).
Bank | Band |
SR0 | Marine |
SR1 | CB |
SR2 | Police/Fire |
SR3 | Aircraft |
SR4 | Ham |
SR5 | Limit search (User changeable) |
To select preprogrammed search bands and search them for active frequencies:
1.Repeatedly press SEARCH to select your desired search bank (/.ò, /.ñ, /.ð,
/.ï, /.î, or /.í).
2.In the marine and CB bands, you can directly select a channel or search through the band. When ) appears at the left most position of the second line, you can directly select a channel (refer to the following band charts). Press the desired channel number while ) appears
to select it. You can also change the channels by pressing 8or 9.
3.Press FUNC then SEARCH while ) appears. ) changes to / and you can search through the band. Press FUNC then SEARCH again to return to the pre- vious mode.
4.Rotate SQUELCH clockwise and leave it set to a point just after the hissing sound stops. After 2 seconds (if the delay fea- ture is on), the received frequency appears and the scanner starts search- ing.
5.When the scanner finds an active fre- quency, it stops searching.
18 | Operation |