Locking Out Talk Group IDs
Note: You can only lock out talk group IDs when the scanner is in the closed mode (see “Open and Closed Modes” on Page 38).
1.Press PROG.
2.Press TRUNK.
3.Press FUNC, 8 or 9to move to the desired bank.
4.Press 8 or 9 to select the ID memory.
5.Press L/OUT to lock out the ID. B appears.
6.To remove the lockout from a trunking
ID, manually select the ID memory, and press L/OUT until (ýdisappears.
While the scanner shows a text tag you can confirm the ID code when the received signal is the voice channel.
1.Press TEXT while the scanner is receiv- ing the voice channel and displaying the text tag. The ID code appears as
)+0è444444 or ! è4444.
2. Press TEXT again to cancel.
Delay Function in ID Indication Mode
You can set the ID delay function separately from channel delay.
1.Press FUNC then ./DELAY while you are programming the trunked ID. 1J<ý 1Gó
FNEýB<PJýKFýJ<Ký% ý;<C8P.ýðôòýJ<:FE;J
appears.
2. Press 8or 9 to select *FE<, òôí, ñôò, ñôí,
ðôò, ðôí, ïôò, ïôí or îôò J<:FE;J.
3. Press ENTER.
If the ID delay is active, it watches the control channel command for the delay time when- ever the signal disappears from the voice channel.
Reviewing Locked-Out Talk Group IDs
Note: You cannot clear all lockouts from a talk group at the same time.
1.Press PROG then TRUNK.
2.Press FUNC then L/OUT. The locked out ID appears. If the ID memory bank has no locked out ID, you hear the low beep tone.
3.Press FUNC then 8 or 9 to select a search bank. Or, just press 8 or 9 to search for any locked out IDs in a bank.
Clearing Talk Group IDs
1.Press PROG then TRUNK.
2.Press FUNC, 8 or 9 to select ID memory.
3.Press FUNC then CLEAR.
Clearing All Talk Group IDs in One Bank
You can clear all talk group IDs within a bank. This lets you quickly delete all talk group IDs from a bank if you want to use the bank to store different data (such as a new set of talk group IDs).
1.Press PROG.
2.Press TRUNK to enter a talk group ID memory mode.
3.Select a talk group ID bank using FUNC, 8 or 9.
Trunking Operation | 37 |