2.Place the HDD inside the HDD bracket and tighten four screws (#1) from both sides of the HDD bracket.
HDD (Bottom up)
Pin 1
1
3.The HDD cable (1 x 44-pin to 1 x 44-pin) is next to the HDD bracket. Connect the HDD cable to the HDD. Make sure that the red wire corresponds to Pin 1 on the connector, which is labelled on the board. Plug the other end of the cable into the HDD, with Pin 1 on the cable corresponding to Pin 1 on the HDD.
3.3Placing the Rubber Seal
To ensure that your PPC-V106 stays dry, the supplied rubber seal must be placed correctly between the front bezel and back cover. Please note the direction of the seal. The mark should be up.
Marked
Flat (UP)
UP
Figure 3.1: Placing the Rubber Seal
