Advantech PPC-V106 user manual Installing the Universal Arm

Page 30

3.4 Installing the Universal Arm

1.Press latches at the same time and then rotate support-1 until you can see both of the screw holes.

2.Rotate support-2 until the angle is the same as support-1.

3.Use four M4x8L screws and attach the U-Arm with the PPC-V106. The 4 stainless screws can be found in the universal arm's box.

4.Use latches adjust the angle of PPC-V106 (every 14.4° on 360°).

Note: Support-1 can be on the right or left.

Latch

Support-2

Support-1

Screw-M4x8L (x4)

PPC-V106

Figure 3.2: Universal Arm

PPC-V106 User Manual

18

Image 30
Contents User’s Manual Fanless Vehicle Mounted Terminal with 10.4 TFT LCDCopyright FCC Class B Packing List Additional Information and Assistance Contact informationSafety Instructions Wichtige Sicherheishinweise Viii Contents Chapter VIA Chipset Appendix a Programming the Watchdog Timer Xii General Information General Specifications IntroductionStandard PC functions Audio function LCD Specifications Backlight lifetime 20,000 hoursDimensions System Setup Quick Tour of the Panel PC Front View of the Panel PCRear Side View of the Panel PC Connecting the Keyboard or Mouse Installation ProceduresConnecting the Power Cord Switching On the PowerRunning the Bios Setup Program Installing System Software Prior to shipment of your panel PCInstalling the Drivers InstallPage Hardware and Peripheral Installation Overview of Hardware Installation and Upgrading Installing the 2.5 Hard Disk Drive HDDPlacing the Rubber Seal Placing the Rubber SealInstalling the Universal Arm Universal ArmJumper Settings and Connectors Setting Jumpers Jumpers and Switches Locating Jumpers and SwitchesConnectors Panel PC connectorsCPU Installation Locating Connectors1 COM2 RS-232/422/485 Setting JP5 Cmos Clear for External RTC JP1COM-port Interface Serial port default settings 2 COM1/COM2/COM3/ Pin 9 Output Setting JP4 COM1/2/3 Pin 9 Output SettingJP4JP3 Setting LCD Panel Power Setting VGA InterfaceVIA Chipset Installation 4-in-1 Driver for Windows 98/2000/XP Further InformationAGP Svga Setup Installation of Svga Driver ChipsetDisplay memory Installation for Windows 98/ME Installation for Windows 2000/XPPage PCI Bus Ethernet Interface Installation of Ethernet Driver Installation for Windows 98/ME Further Information Audio Installation of Audio Driver USB Installation of USB 2.0 Driver Driver Installation for Windows XPDriver Installation for Windows Driver Installation for Windows ME / 98 / 98SE Touchscreen General specifications General informationInstallation of Touchscreen Drivers Environmental SpecificationsInstallation of Resistive T/S driver for Windows 98/ME Installation of Resistive T/S driver for Windows 2000/XP Installation of Infrared T/S driver for Windows 2000/XPPage Programming the Watchdog Timer Appendix a Programming the Watchdog Timer Programming the Watchdog TimerMOV DX,2EH MOV DX,2EH MOV AL,AAH Pin Assignments Inverter Power Connector CN10 Internal Speaker Connector CN14Appendix B Pin Assignments Floppy Drive Connector CN16 Reserved Table B.3 Floppy drive connector CN16IDE Hard Disk Drive Connector CN15 IR Connector CN8 Reserved Lvds Connector CN4Flat Panel Display Connector CN2 Reserved COM1 COM211 COM3 Connector CN 10 COM3COM 4 Connector CN USB PortParallel Port Connector CN11 VGA Connector