Advantech PPC-V106 user manual Installation of Svga Driver, Chipset, Display memory

Page 44

Chapter 6 AGP SVGA Setup

6.1 Introduction

The PPC-V106 has an onboard integrated VGA chipset The specifica- tions and features are described as follows:

6.1.1 Chipset

The VIA CLE266 boasts a complete integrated VIA 128-bit 2D/3D graphics engine with a high quality video processing unit including MPEG-2 decoding, video scaling and Alpha Blending.

6.1.2 Display memory

The integrated VGA chipset can support 8 / 16 / 32 / and 64 MB frame buffer using system memory.

6.2 Installation of SVGA Driver

Important:

The following are examples only. You must fol-

 

low the instructions and pay attention to the

 

instructions which then appear on your screen.

Note:

The CD-ROM drive is designated as "D"

 

throughout this chapter.

PPC-V106 User Manual

32

Image 44
Contents User’s Manual Fanless Vehicle Mounted Terminal with 10.4 TFT LCDCopyright FCC Class B Packing List Additional Information and Assistance Contact informationSafety Instructions Wichtige Sicherheishinweise Viii Contents Chapter VIA Chipset Appendix a Programming the Watchdog Timer Xii General Information General Specifications IntroductionStandard PC functions Audio function LCD Specifications Backlight lifetime 20,000 hoursDimensions System Setup Quick Tour of the Panel PC Front View of the Panel PCRear Side View of the Panel PC Installation Procedures Connecting the Power CordConnecting the Keyboard or Mouse Switching On the PowerRunning the Bios Setup Program Installing System Software Prior to shipment of your panel PCInstalling the Drivers InstallPage Hardware and Peripheral Installation Overview of Hardware Installation and Upgrading Installing the 2.5 Hard Disk Drive HDDPlacing the Rubber Seal Placing the Rubber SealInstalling the Universal Arm Universal ArmJumper Settings and Connectors Setting Jumpers Jumpers and Switches Locating Jumpers and SwitchesConnectors Panel PC connectorsCPU Installation Locating ConnectorsCOM-port Interface 1 COM2 RS-232/422/485 Setting JP5Cmos Clear for External RTC JP1 Serial port default settings 2 COM1/COM2/COM3/ Pin 9 Output Setting JP4 COM1/2/3 Pin 9 Output SettingJP4JP3 Setting LCD Panel Power Setting VGA InterfaceVIA Chipset Installation 4-in-1 Driver for Windows 98/2000/XP Further InformationAGP Svga Setup Display memory Installation of Svga DriverChipset Installation for Windows 98/ME Installation for Windows 2000/XPPage PCI Bus Ethernet Interface Installation of Ethernet Driver Installation for Windows 98/ME Further Information Audio Installation of Audio Driver USB Installation of USB 2.0 Driver Driver Installation for Windows XPDriver Installation for Windows Driver Installation for Windows ME / 98 / 98SE Touchscreen General specifications General informationInstallation of Touchscreen Drivers Environmental SpecificationsInstallation of Resistive T/S driver for Windows 98/ME Installation of Resistive T/S driver for Windows 2000/XP Installation of Infrared T/S driver for Windows 2000/XPPage Programming the Watchdog Timer Appendix a Programming the Watchdog Timer Programming the Watchdog TimerMOV DX,2EH MOV DX,2EH MOV AL,AAH Pin Assignments Appendix B Pin Assignments Inverter Power Connector CN10Internal Speaker Connector CN14 Floppy Drive Connector CN16 Reserved Table B.3 Floppy drive connector CN16IDE Hard Disk Drive Connector CN15 IR Connector CN8 Reserved Lvds Connector CN4Flat Panel Display Connector CN2 Reserved COM1 COM211 COM3 Connector CN 10 COM3COM 4 Connector CN USB PortParallel Port Connector CN11 VGA Connector