Chapter 4 Jumper Settings and Connectors
4.1 Setting Jumpers
You can configure your panel PC to match the needs of your application by setting jumpers. A jumper is the simplest kind of electrical switch. It consists of two metal pins and a small metal clip (often protected by a plastic cover) that slides over the pins to connect them. To “close” a jumper, you connect the pins with the clip. To “open” a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1, 2, and 3. In this case, you would connect either pins 1 and 2 or pins 2 and 3.
open | closed | closed |
open | closed | closed |
A pair of
An arrow is used on the motherboard to indicate the first pin of jumpers.
20 |