Metrologic Instruments MS6130 MX003 Enabling the MS700I/MS720I SCANNER’S RF LOW Speed Option

Page 20

ENABLING THE MS700I/MS720I SCANNER’S RF LOW SPEED OPTION

Before beginning this procedure, perform all steps in the sections, Matching the Transmitter to the Receiver and Configuration of the MS700i/MS720i with “MX”.

Use the MS700i/MS720i scanner to scan the following bar codes.

1.Temporarily cover the bar code below Step 3. Scan the following bar code to enter program mode.

(The MS700i scanner will beep three times):

Enter/Exit Program Mode for the Receiver

01 2 3 4 5

6 6 6 6 6

7

2.Temporarily cover the bar code in Step 1. Scan the Enable RF Low Speed Option bar code below Step 3.

3.Exit program mode by scanning the bar code in Step 1 again.

Enable RF Low Speed Option

01 2 3 4 5

1 2 9 1 5

5

16

Image 20

Contents Metrologic INSTRUMENTS, INC Table of Contents Table of Contents Printer Note Leave page blank MS6130 Hand Held BAR Code Scanner MX003 Series Scanner Interfaces Receiver Group Unpacking ListTransmitter Group Connections of the Mxnterfacei to the Host Device Except versionConnections of the Keyboard Wedge Mxnterfacei to the PC Version 17 onlyConnections of the MS700I/MS720I With Mxto the Host Device Configuration of the MS700I/MS720I with MX Page Configuration of the Mxto the Scanpal Data Collector Page Keyboard Wedge KB Interface KB Parameter Keyboard TypeKB Parameter Keyboard Type KB Parameter Caps Lock Mode KB Parameter Alt Mode Microsecond DelayMillisecond Delay Millisecond Delay KB Parameter XT Clean-Up BitConfiguration of the MS6130 HAND-HELD Enabling the MS700I/MS720I SCANNER’S RF LOW Speed Option Changing the ID Handset /XMatching Procedure Parts of the MS6130 HAND-HELD BAR Code Scanner Output WindowComponents of the MS6130 Series Stand Installation of the MS6130 Series Stand Installation of the 6000 Series Universal Charging Stand Permanent Counter TOP InstallationNicd Battery Charger with Reconditioning Feature Recommended USEVisual Indicators Audible Indicators One BeepRazzberry Tone Two BeepsAudible Indicators Maintenance LabelsTroubleshooting Specifications Appendix aMX003 Series Scanner Interface Specifications Temperature Characteristics Degrees Celsius of each Cell Default Settings of the MS6130 and MX Receiver Appendix BRTS/CTS UPC EAN Parameter Transmitter Default Keyboard Receiver Wedge Pin Function Appendix CMX003 Series Scanner Interface Pin Assignments Appendix E Appendix F PatentsIndex ESDTroubleshooting