AUDIBLE INDICATORS
When the scanner and “MX” receiver are in operation, they provide audible indications. These sounds indicate the status of the scan and scanner.
One Beep | When the “MX” Receiverfirst receives power, the unit will | |||||
|
|
|
|
|
| beep once. |
|
|
|
|
|
| If the scanner successfully reads a bar code, the green |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| light will flash. If the “MX” receiver successfully receives |
|
|
|
|
|
| the data from the MS6130, the “MX” will beep once. |
Razzberry Tone | If, upon power up, the scanner emits a razzberry tone, | |||||
|
|
|
|
|
| then the scanner has failed diagnostics. |
|
|
|
|
|
| The “MX” receiver will emit a razzberry tone if an invalid |
|
|
|
|
|
| |
|
|
|
|
|
| bar code is scanned while the receiver is in program |
|
|
|
|
|
| mode. |
|
|
|
|
|
| The “MX” receiver can be programmed to emit a |
|
|
|
|
|
| razzberry tone when the timeout occurs during |
|
|
|
|
|
| communication between the host and receiver. |
|
|
|
|
|
| Refer to the MS4120 Programming Guide section, |
|
|
|
|
|
| Audible Indicators for Communication Timeouts to |
|
|
|
|
|
| program this feature. |
Two Beeps | The MS6130 scanner will quietly beep twice when | |||||
|
|
|
|
|
| scanning a bar code if the batteries become low. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Three Beeps When scanning the MS6130 Enter/Exit Program Mode bar code in the MS4120 Programming Guide, the green
LED will flash three times while the scanner
simultaneously beeps three times. When exiting the program mode, the same visual and audible indications will occur. After this sequence is completed, the red LED will turn off. When scanning the Enter/Exit Program Mode for the Receiver bar code, the “MX” receiver will beep three times to indicate it is in or exiting out of the program mode.
(continued next page)
25