Metrologic Instruments MS6130 MX003 manual Configuration of the Mxto the Scanpal Data Collector

Page 13

CONFIGURATION OF THE “MX”TO THE SCANPAL®

DATA COLLECTOR

To perform matching procedure refer to page 18.

The RS-232 parameters marked with an asterisk ( * ) in the charts are the default settings of the “MX”. The charts are in theDefault Settings of the MS6130 and “MX” Receiver section of this guide. To communicate with each other properly, the “MX” and ScanPal must have matching RS-232 parameters. However, the Enter/Exit Program Mode bar code in the MS4120 Programming Guide will not cause your “MX” to enter or exit program mode. Scan the Enter/Exit Program Mode for the Receiver bar code in the following procedure.

Before completing RF communication, program the ScanPal to the same settings as the IBM® PC XT, AT or PS/2 compatible computer. Once completed and the receiver and MS6130 have the same assigned ID number, configure the “MX” to the same settings as ScanPal.

1.Program the ScanPal to the same settings as the PC.

(Refer to the Programming the ScanPal section in the ScanPal® Data Collector Installation and User’s Guide)

2.Scan the following bar code to enter program mode. (The “MX” receiver will beep three times):

Enter/Exit Program Mode for the Receiver

01 2 3 4 5

 

 

 

 

 

 

 

 

 

 

 

 

 

6 6 6 6 6

 

 

 

7

3.Scan the appropriate communication options in the MS4120 Programming Guide.

4.Exit program mode by scanning the bar code in Step 1 again.

Note: Scan the Enter/Exit Program Mode for the Receiver bar code and exit program mode if the PC uses the same parameters as the default settings of ScanPal.

Default to ScanPal Communication Parameters

I B 5

9

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Metrologic INSTRUMENTS, INC Table of Contents Table of Contents Printer Note Leave page blank MS6130 Hand Held BAR Code Scanner MX003 Series Scanner Interfaces Transmitter Group Unpacking ListReceiver Group Except version Connections of the Mxnterfacei to the Host DeviceVersion 17 only Connections of the Keyboard Wedge Mxnterfacei to the PCConnections of the MS700I/MS720I With Mxto the Host Device Configuration of the MS700I/MS720I with MX Page Configuration of the Mxto the Scanpal Data Collector Page KB Parameter Keyboard Type Keyboard Wedge KB InterfaceKB Parameter Keyboard Type KB Parameter Caps Lock Mode Microsecond Delay KB Parameter Alt ModeMillisecond Delay Millisecond Delay KB Parameter XT Clean-Up BitConfiguration of the MS6130 HAND-HELD Enabling the MS700I/MS720I SCANNER’S RF LOW Speed Option Handset /X Changing the IDMatching Procedure Output Window Parts of the MS6130 HAND-HELD BAR Code ScannerComponents of the MS6130 Series Stand Installation of the MS6130 Series Stand Permanent Counter TOP Installation Installation of the 6000 Series Universal Charging StandRecommended USE Nicd Battery Charger with Reconditioning FeatureVisual Indicators One Beep Audible IndicatorsRazzberry Tone Two BeepsAudible Indicators Labels MaintenanceTroubleshooting Appendix a SpecificationsMX003 Series Scanner Interface Specifications Temperature Characteristics Degrees Celsius of each Cell Appendix B Default Settings of the MS6130 and MX ReceiverRTS/CTS UPC EAN Parameter Transmitter Default Keyboard Receiver Wedge MX003 Series Scanner Interface Pin Assignments Appendix CPin Function Appendix E Patents Appendix FESD IndexTroubleshooting
Top Page Image Contents