Metrologic Instruments MS6130 MX003 manual Appendix E

Page 41

APPENDIX E

Notices

Notice - applicable to 912 MHZ devices only

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any unauthorized changes or modifications to this equipment could void the users authority to operate this device.

Notice - applicable to 912 MHZ devices when used in Canada

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Caution

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous laser light. Under no circumstances should the customer attempt to service the laser scanner. Never attempt to look at the laser beam, even if the scanner appears to be nonfunctional. Never open the scanner in an attempt to look into the device. Doing so could result in hazardous laser light exposure. The use of optical instruments with the laser equipment will increase eye hazard.

38

Image 41
Contents Metrologic INSTRUMENTS, INC Table of Contents Table of Contents Printer Note Leave page blank MS6130 Hand Held BAR Code Scanner MX003 Series Scanner Interfaces Receiver Group Unpacking ListTransmitter Group Except version Connections of the Mxnterfacei to the Host DeviceVersion 17 only Connections of the Keyboard Wedge Mxnterfacei to the PCConnections of the MS700I/MS720I With Mxto the Host Device Configuration of the MS700I/MS720I with MX Page Configuration of the Mxto the Scanpal Data Collector Page KB Parameter Keyboard Type Keyboard Wedge KB InterfaceKB Parameter Keyboard Type KB Parameter Caps Lock Mode Microsecond Delay KB Parameter Alt ModeMillisecond Delay Millisecond Delay KB Parameter XT Clean-Up BitConfiguration of the MS6130 HAND-HELD Enabling the MS700I/MS720I SCANNER’S RF LOW Speed Option Handset /X Changing the IDMatching Procedure Output Window Parts of the MS6130 HAND-HELD BAR Code ScannerComponents of the MS6130 Series Stand Installation of the MS6130 Series Stand Permanent Counter TOP Installation Installation of the 6000 Series Universal Charging StandRecommended USE Nicd Battery Charger with Reconditioning FeatureVisual Indicators One Beep Audible IndicatorsRazzberry Tone Two BeepsAudible Indicators Labels MaintenanceTroubleshooting Appendix a SpecificationsMX003 Series Scanner Interface Specifications Temperature Characteristics Degrees Celsius of each Cell Appendix B Default Settings of the MS6130 and MX ReceiverRTS/CTS UPC EAN Parameter Transmitter Default Keyboard Receiver Wedge Pin Function Appendix CMX003 Series Scanner Interface Pin Assignments Appendix E Patents Appendix FESD IndexTroubleshooting