Metrologic Instruments MS6130 MX003 manual Nicd Battery Charger with Reconditioning Feature

NICD BATTERY CHARGER WITH RECONDITIONING FEATURE

MLPN: 45561 - 115V and 45562 - 230V

How to Recondition

Transformer

Discharge

Cycle Switch

Red LED	Green LED
(Power)	(Charge Status)

Figure 6: Reconditioning

1.	Place the scanner into the
	charge stand.
2.	Push the stand tilt cup in
	the extreme down position
	to expose the hole for the
	discharge cycle switch.
3.	Use a pin to push the
	discharge cycle switch
	located beneath the hole.
4.	When the discharge mode
	is initiated the green LED
	flashes.

RECOMMENDED USE

To maintain charge capacity, the NiCd batteries must be discharged fully before charging. We call this process reconditioning.

Recondition if:

∙The batteries were not used within 20 days

∙The batteries were not discharged (approximately two hours of continuous operation) at least once a week

∙Low battery indicators:

∙Both LED’s on the scanner blink

∙The scanner quietly beeps twice while scanning

Recondition once a week if:

∙The batteries do not get discharged for more than 20% (approximately ½ hour) of their capacity before recharging.

Recondition once every two weeks if:

∙The batteries do not get discharged for more than 50% (approximately 1 hour) of their capacity before recharging.

Note: The day to day usage of the NiCd batteries will determine the frequency of the discharges (reconditioning).

Charge State	CHG LED Status
Battery Absent	LED off
Charge Pending	LED on for 0.125sec, off for
	1.375sec
Discharge-Before-	LED on for 1.375sec, off for
Charge	0.125sec
Fast-Charge	LED on
Charge Complete Top-	LED on for 0.125 sec, off for
Off	0.125sec

23