Cino FM400 manual Data Verifier Setting, Verifier Control

Mount	Manual
FuzzyScanFixed	Programming
	Scan

Condensed DataWizard

♦ Data Verifier Setting ♦

PROGRAM					F_DEFAULT
Family Code Selection	P.C	Parameter Selection		Option Code	2nd Option Code
Verifier Control	SS	Disable ￿		FIN
	MS	Select one bar code symbology		(2 digits)	automatic termination
	MS	Select all bar code symbologies	00		automatic termination
Identified Data Length	SS	Disable ￿		FIN
	DS	Enable		(2 digits)
		Determine the identified data length for verification.
1st Identified Character	SS	Disable ￿		FIN
	DS	Enable		(2 digits)	[00-7F]
		2-digits checking position; 1 identified character		position
2nd Identified Character	SS	Disable ￿		FIN
	DS	Enable		(2 digits)	[00-7F]
		2-digits checking position; 1 identified character		position
3rd Identified Character	SS	Disable ￿		FIN
	DS	Enable		(2 digits)	[00-7F]
		2-digits checking position; 1 identified character		position

￿The Data Verifier is used to provide advanced verification for error-free scanning and to work as an Embedded Data Transmitting Filter.

￿All data must conform to the Identified Bar Code Symbologies, Identified Data Length, and one to three Identified Characters in the checking position. Otherwise, the FuzzyScan will not transmit the data to the host computers or terminals, but will instead issue 3 long beeps for verification error and skip the scanned data.

￿The Data Verifier checks only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix.

￿Regarding the “Bar Code Selection” and “Position Calculation” of Data Verifier, please refer to page 49 for details.

￿Please note that all “Character” input should be referred to the ASCII/HEX Table listed in Appendix to find matched HEX value.

51