FixedMount Manual |
Programming Procedure
[Data Verifier]
Scan “Program” to enter the programming mode.
Scan “Verifier Control” and set bar code symbology to “48” (Interleaved 2 of 5).
Scan “Identified Data Length” and set the length to “16”.
Scan “1st Identified Character” and set the identified position to “00”, then set the identified character to “39” (Hex Code of 9).
[Data Formatter]
Scan “Formatter Control” and set bar code symbology to “48”.
Scan 1st Insertion” and set the identified position to “06”, then inserted characters to “09” (Hex Code of TAB), “53” (Hex Code of S), “4E” (Hex Code of N).
Scan “2nd Insertion” and set the identified position to “12”, then inserted character to “09”. In the final, you must scan “FIN” (Finish) code to terminate this selection.
Scan “3rd Insertion” and set the identified position to “16”, then inserted character to “09”. In the final, you must scan “FIN” (Finish) code to terminate this selection.
[Data Replacer]
Scan “Replacer Control” and set bar code symbology to “48”.
Scan “1st Replacement” and set the identified position to “00”, then replaced character to “41” (Hex Code of A).
[Data Organizer]
Scan “Organizer Control” and set bar code symbology to “48”.
Scan “1st Organization” and set the identified position to “16”, then set the data transmission to “0” (forward).
Scan “2nd Organization” and set the identified position to “17”, then set the data transmission to “1” (backward).
Scan “END” (Exit) to terminate the programming.
[Important Notice]
Please note that Condensed DataWizard will follow the preset working flow as below:
Verifier Formatter Replacer Organizer
FuzzyScan | Scan |
Programming |
So when you set the identified position in Data Organizer, you must consider the inserted data which you already set via Data Formatter.
55