Cino FM400 manual Data Replacer Setting, Replacer Control

Condensed DataWizard

Mount Manual

♦ Data Replacer Setting ♦

PROGRAM
Family Code Selection	P.C	Parameter Selection		Option Code
Replacer Control	SS	Disable ￿		FIN
	MS	Select one bar code symbology		(2 digits)
	MS	Select all bar code symbologies	00
1st Replacement	SS	Disable ￿		FIN
	DS	Enable		(2 digits)
		2-digits identified position; 1 replacement character		position
2nd Replacement	SS	Disable ￿		FIN
	DS	Enable		(2 digits)
		2-digits identified position; 1 replacement character		position
3rd Replacement	SS	Disable ￿		FIN
	DS	Enable		(2 digits)
		2-digits identified position; 1 replacement character		position

F_DEFAULT

2nd Option Code

automatic termination automatic termination

[00-7F]

[00-7F]

[00-7F]

FuzzyScanFixed	Scan
	Programming

￿The Data Replacer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code symbologies for replacer control, and provides Multiple Position Replacement in the identified position.

￿All data must conform to the Identified Bar Code Symbologies, and one to three Identified Characters in the identified position While the Data Replacer is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix.

￿Regarding the “Bar Code Selection” and “Position Calculation” of Data Replacer, please refer to page 49 for details.

￿Please note that all “Character” input should be referred to the ASCII/HEX Table listed in Appendix to find matched HEX value.

52