Premier Mounts EST150 installation instructions Mounting Hardware Too Long?

Page 11

EST150

Mounting Hardware Too Long?

The depth of some projector mount points may prevent you from tightening the M2.5 and M3 mounting hardware.

You can reduce the length of the M2.5 and

M3 mounting hardware by stacking up to a maximum of five (5) M3 flat washers inside the leveling barrel.

Avoid stacking too many M3 washers; the mounting hardware must thread into the projector mount point at least four (4) complete turns.

Step 4

1)Identify the projector’s approximate front-to-back center of gravity. Place your hands on each side of the projector and gently lift it an inch from the surface on which it is resting. Carefully adjust your grip on the projector until it seems balanced from front-to-back. Mentally note the apparent center of gravity.

2)Identify the projector’s approximate side-to-side center of gravity. Place your hands on the front and back of the projector and gently lift it an inch from the surface on which it is resting. Carefully adjust your grip on the projector until it seems balanced from side-to-side. Mentally note the apparent center of gravity.

3)Make sure the mount carriage is as close as possible to the projector’s center of gravity.

Side-to-Side

Center of Gravity

Front-to-Back

Center of Gravity

Step 5

1) Position the legs accordingly for best configuration.

 

You may raise or lower each leg independently by

Sliding M6

turning the leveling barrels.

Square Nut

2)Secure the legs to the mount carriage by screwing

M6 x 12mm security screws into the M6 square nut (do not overtighten) on the mounting legs.

3)Verify the position of the integrated sliding M6 square nut in the mounting leg relative to a nearby slot on the mount carriage.

If the M6 square nut is not aligned with any slot, you can use any thin implement, such as a toothpick, to nudge it into alignment.

Installation Instructions

Visit the Premier Mounts website at http://www.premiermounts.com

Page 11

Image 11
Contents Installation Instructions Weight Capacity Table of ContentsParts List Installation ToolsEST-WP Optional FeaturesProceed to the Wood Stud Installation section Determining the Installation HeightEST150 Installation Step Wood Stud InstallationGo to the Throw Distance Calculation section on Proceed to the Attaching the Mount Carriage section Proceed to the Projector Installation sectionThrow Distance Calculation Attaching the Mount Carriage Selecting the Mounting Hardware Multiple Mounting Point Installation Step Mounting Hardware Too Long? Proceed to the Attaching the Mount Carriage to Single Mounting Point InstallationGo to the Attaching the Mount Carriage to Attaching the Mount Carriage to the Projector Arm Step Proceed to the Securing the Projector Optional section Cable Routing OptionalSecuring the Projector Optional Technical Specifications Mount AdjustmentDisclaimer Warranty