Premier Mounts EST150 Attaching the Mount Carriage Selecting the Mounting Hardware

Page 9

EST150

Attaching the Mount Carriage

Selecting the Mounting Hardware

1)Insert a small straw or toothpick into the threaded inserts found on the bottom or top of the projector.

2)Use a pencil to mark the depth of the threaded insert on the small straw or toothpick.

3)Mark the straw or toothpick 1/8” above the depth of the threaded insert, as shown in Figure 1.

4)Insert the small straw or toothpick into the remaining threaded inserts to compare and verify their depth using the straw or toothpick’s 1/8” allowance mark.

5)Locate the correct diameter screw for the threaded insert.

If the screw you selected is longer than the 1/8” allowance mark on the small straw or toothpick, as shown in Figure 2 and Figure 3, do not use this screw. The screw length must not bypass the mark.

6)Test each size of the screws provided. The correct screws should thread easily into the mounting point and not pull out when tension is applied.

Does your projector have multiple mounting points or a single mounting point?

If your projector has multiple mounting points, proceed to the “Multiple Mounting Point Installation” section.

If your projector has a single mounting point, skip to the “Single Mounting Point Installation” section on page 14.

Small Straw or Toothpick

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Small Straw

 

 

 

Depth Plus 1/8” Allowance

 

 

Small Straw

 

 

 

or Toothpick

 

 

 

Mark

 

 

or Toothpick

 

 

Marking the 1/8”

Allowance

Depth Plus 1/8” Allowance

Mark

Installation Instructions

Visit the Premier Mounts website at http://www.premiermounts.com

Page 9

Image 9
Contents Installation Instructions Weight Capacity Table of ContentsParts List Installation ToolsEST-WP Optional FeaturesProceed to the Wood Stud Installation section Determining the Installation HeightEST150 Installation Step Wood Stud InstallationGo to the Throw Distance Calculation section on Proceed to the Projector Installation section Throw Distance CalculationProceed to the Attaching the Mount Carriage section Attaching the Mount Carriage Selecting the Mounting Hardware Multiple Mounting Point Installation Step Mounting Hardware Too Long? Single Mounting Point Installation Go to the Attaching the Mount Carriage toProceed to the Attaching the Mount Carriage to Attaching the Mount Carriage to the Projector Arm Step Cable Routing Optional Securing the Projector OptionalProceed to the Securing the Projector Optional section Technical Specifications Mount AdjustmentDisclaimer Warranty