Premier Mounts EST150 installation instructions Table of Contents, Weight Capacity

Page 2

EST150

Table of Contents

 

Heading 1

2

Weight Capacity

Warning Statements

2

Installation Tools

3

Parts List

3

Features

4

Determining the Installation Height

5

Wood Stud Installation

6

Throw Distance Calculation

8

Projector Installation

8

Attaching the Mount Carriage

9

Multiple Mounting Point Installation

10

Single Mounting Point Installation

12

Attaching the Mount Carriage to the Projector Arm

13

Cable Routing (Optional)

14

Securing the Projector (Optional)

14

Mount Adjustment

15

Technical Specifications

15

Warranty

16

Disclaimer

16

Weight Capacity

Maximum projector weight:

25 lbs.

THE WALL STRUCTURE MUST BE CAPABLE OF HOLDING FIVE

(5) TIMES THE WEIGHT OF THE PROJECTOR. IF NOT, THEN THE

 

 

WALL STRUCTURE MUST BE REINFORCED.

 

 

 

Warning Statements

 

 

PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS SHOULD BE READ AND COMPLETELY UN- DERSTOOD. THE INSTALLATION INSTRUCTIONS MUST BE READ TO PREVENT PERSONAL INJURY AND PROPERTY DAMAGE. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REFERENCE.

PREMIER MOUNTS DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY PREMIER MOUNTS PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS, ACTIONS OR CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER RELATING TO ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.

SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS PRODUCT. USE PROPER SAFETY GEAR AND TOOLS FOR THE ASSEMBLY PROCEDURE TO PREVENT PERSONAL INJURY.

At least two qualified people should perform the assembly procedure. Injury and/or damage can result from dropping or mishandling the projector.

If mounting to studs, make sure that the mounting screws are anchored into the center of the studs. Use of an edge-to-edge stud finder is recommended.

Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that there are no electrical wires in wall. Cutting/drilling into an electrical line may cause serious injury.

Make sure there are no water lines inside the wall where the mount is to be located. Cutting/drilling into a water line may cause severe water damage to the mounting surface.

This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury. Do not install near sources of high heat. Do not install on a structure that is prone to vibration, movement or chance of impact

Contact Premier Mounts with any questions

(800)368-9700 techsupport@mounts.com

Page 2

Visit the Premier Mounts website at http://www.premiermounts.com

Installation Instructions

Image 2
Contents Installation Instructions Table of Contents Weight CapacityInstallation Tools Parts ListFeatures EST-WP OptionalDetermining the Installation Height Proceed to the Wood Stud Installation sectionWood Stud Installation EST150 Installation StepGo to the Throw Distance Calculation section on Proceed to the Attaching the Mount Carriage section Proceed to the Projector Installation sectionThrow Distance Calculation Attaching the Mount Carriage Selecting the Mounting Hardware Multiple Mounting Point Installation Step Mounting Hardware Too Long? Proceed to the Attaching the Mount Carriage to Single Mounting Point InstallationGo to the Attaching the Mount Carriage to Attaching the Mount Carriage to the Projector Arm Step Proceed to the Securing the Projector Optional section Cable Routing OptionalSecuring the Projector Optional Mount Adjustment Technical SpecificationsWarranty Disclaimer