Premier Mounts EST150 Throw Distance Calculation, Proceed to the Projector Installation section

Page 8

EST150

Throw Distance Calculation

Please review the Operator’s Manual that came packaged with your projector before attaching the upper mounting bracket. The correct throw distance (the distance from the projector to the screen) must be determined prior to mounting the projector.

1)Refer to the projectors User’s Manual to determine the distance from the lens to the front of the screen (X).

2)Measure the distance from the front of the lens to the center of the projector (Y).

3)Measure the distance from the wall to the face of the whiteboard/screen (Z).

4)Add all measurements (X + Y + Z) to determine projector placement on the arm assembly. This measurement will determine where the center of the mount bracket will be located on the arm assembly. Please make note of this measurement.

The EST150 can be also used as a wall-mounted standard projector mount as well as a short throw projector mount. Align the projector facing the opposite direction from the wall plate to project the image across the room. Please take into account the projectors throw capabilities prior to mounting in the projector opposite direction.

Calculations

X = Manufacturers recommended throw distance

Z = Distance from wall to face of whiteboard/screen

Front Lens Throw Distance =

(X + Y + Z)

Rear Lens Throw Distance =

(X - Y + Z)

Front Lens

Rear Lens

Proceed to the “Projector Installation” section.

Projector Installation

Attaching the Projector to the Mount Carriage

Locate the mounting points on the bottom of the projector (see arrows).

Proceed to the “Attaching the Mount Carriage” section.

Page 8

Visit the Premier Mounts website at http://www.premiermounts.com

Installation Instructions

Image 8
Contents Installation Instructions Table of Contents Weight CapacityInstallation Tools Parts ListFeatures EST-WP OptionalDetermining the Installation Height Proceed to the Wood Stud Installation sectionWood Stud Installation EST150 Installation StepGo to the Throw Distance Calculation section on Proceed to the Attaching the Mount Carriage section Proceed to the Projector Installation sectionThrow Distance Calculation Attaching the Mount Carriage Selecting the Mounting Hardware Multiple Mounting Point Installation Step Mounting Hardware Too Long? Proceed to the Attaching the Mount Carriage to Single Mounting Point InstallationGo to the Attaching the Mount Carriage to Attaching the Mount Carriage to the Projector Arm Step Proceed to the Securing the Projector Optional section Cable Routing OptionalSecuring the Projector Optional Mount Adjustment Technical SpecificationsWarranty Disclaimer