Premier Mounts EST150 installation instructions Determining the Installation Height

Page 5

EST150

Determining the Installation Height

In order to determine the installation height and throw distance, the mount carriage must be mounted to the projector.

Refer to the projectors User’s Manual to determine the offset of the projector lens to the top of the screen/whiteboard (B).

Mount Carriage

Projector

Lens

1)Measure distance from center of lens to the top of the mount carriage (C).

2)Add the distance from the ground to the top of the screen (A). Add the projector manufacturers recommended offset from the projector manual (B). Add the measurement from Step 1 (C), and then add the mounting screw offset (D) to the total.

(Example: A + B + C + D = ?)

3)Add the measurements to determine the mounting height mark. Place a mark at the top of the total calculated height measurement starting from the ground up. This height mark will determine your mounting points.

Legend

A - Distance from ground to the top of the screen/whiteboard (viewable area).

B - Manufacturers recommended offset measurement. This measurement will be listed in the Users Manual.

C - Center of the lens to the top of the projector bracket.

D - If single-stud EST150, add 5.14˝ to the calculated total.

This total distance will be the location for the lower mounting point.

Proceed to the “Wood Stud Installation” section.

Mark

Top of Screen

Ground

D

Installation Instructions

Visit the Premier Mounts website at http://www.premiermounts.com

Page 5

Image 5
Contents Installation Instructions Weight Capacity Table of ContentsParts List Installation ToolsEST-WP Optional FeaturesProceed to the Wood Stud Installation section Determining the Installation HeightEST150 Installation Step Wood Stud InstallationGo to the Throw Distance Calculation section on Proceed to the Attaching the Mount Carriage section Proceed to the Projector Installation sectionThrow Distance Calculation Attaching the Mount Carriage Selecting the Mounting Hardware Multiple Mounting Point Installation Step Mounting Hardware Too Long? Proceed to the Attaching the Mount Carriage to Single Mounting Point InstallationGo to the Attaching the Mount Carriage to Attaching the Mount Carriage to the Projector Arm Step Proceed to the Securing the Projector Optional section Cable Routing OptionalSecuring the Projector Optional Technical Specifications Mount AdjustmentDisclaimer Warranty