Premier Mounts EST150 installation instructions Mount Adjustment, Technical Specifications

Page 15

EST150

Mount Adjustment

After the projector has been installed, the projector must then be adjusted. To adjust the projector:

1)Loosen the M5 set screw using the M5 Allen wrench (both sides).

2)Adjust the projector to the correct position. Firmly grasp the projector in both hands, and tilt either forward or backward to adjust the level.

-OR-

1)Firmly grasp the projector in both hands and rotate side to side for orientation adjustment.

2)Tighten both M5 set screws using the M5 Allen wrench.

M5 Set Screw

Technical Specifications

All measurements are in inches(mm).

3.25

8.59

83

218

49.42 1255

1.81

46

6.37

162

2.00

51

Ø1 3.79 350

Installation Instructions

Visit the Premier Mounts website at http://www.premiermounts.com

Page 15

Image 15
Contents Installation Instructions Weight Capacity Table of ContentsParts List Installation ToolsEST-WP Optional FeaturesProceed to the Wood Stud Installation section Determining the Installation HeightEST150 Installation Step Wood Stud InstallationGo to the Throw Distance Calculation section on Proceed to the Projector Installation section Throw Distance CalculationProceed to the Attaching the Mount Carriage section Attaching the Mount Carriage Selecting the Mounting Hardware Multiple Mounting Point Installation Step Mounting Hardware Too Long? Single Mounting Point Installation Go to the Attaching the Mount Carriage toProceed to the Attaching the Mount Carriage to Attaching the Mount Carriage to the Projector Arm Step Cable Routing Optional Securing the Projector OptionalProceed to the Securing the Projector Optional section Technical Specifications Mount AdjustmentDisclaimer Warranty