Cable routing
Cable routing
Routing the signal cables
•Bind the cables in the connector compartment together with the cable tie inside the connector compartment.
•Put the connector compartment cover back on the display. Pay attention that the signal cables are positioned under the bulge in the cover.
•Push the cables into the clips on the rear of the tilt & swivel foot.
•Bind the cables together above and under the foot, by means of the 2 velcro strips attached to the inside of the foot cover (packed inside the accessory box).
•At last, put the foot cover back in place.
To put the foot cover in place:
(2)
Figure 17:
1.The foot cover is packaged separately in the accessory box. Unpack the foot cover.
2.Push the upper side of the cover onto the foot, so that the hooks inside the cover are positioned right under the bulges at the rear of the foot.
47