Brother 515 manual Remote Control Commands, Remote control commands Detail Operation

84 C H A P T E R N I N E

Remote Control Commands

Follow the commands below to access features remotely. When you call the fax machine and enter your Remote Access Code (159), the system will signal you with two short beeps to enter a remote control command.

	Remote control commands				Detail Operation
91		Playing voice messages			After one long beep, the machine plays ICM and Memo.
		1	Z (Skip back)		Press 1 while listening to an ICM or Memo to play it again. If you press
					1 before a message, you will hear the previous message.
		2	X (Skip next)		While playing ICM and Memo, you can skip to next message.
		9	STOP Playing		Stop playing the ICM and Memo.
92		Record Memo			After one long beep, you can record a memo. You can stop recording by
					pressing 9.
	93 Erase all ICM & Memo				If you hear one long beep, the erase is accepted. If you hear three short
					beeps, you cannot erase because all voice messages have not been
					played, or there is no voice message to erase.
					*This code erases all recorded messages, not one at a time.
	94 Play and Record OGM in
		memory
	1 Play			1 TAD MSG	The machine plays the selected OGM. You can stop playing OGMs by
					pressing 9.
				2 F/T MSG
				3 PAGING MSG
	2 Record			1 TAD MSG	After one long beep, you can record the selected OGM. You will hear the
				2 F/T MSG	message played once. You can stop recording the message by pressing 9.
				3 PAGING MSG
95		Changing Fax Forwarding/			If you hear one long beep, the change is accepted. If you hear three short
		Paging setting			beeps, you cannot change it because the conditions have not been met
					(Example: registering paging number).
		1	OFF
					You can register your fax forwarding number by using
					4. FAX FWD NO (See “Changing Fax Forwarding Number” in this
		2	Fax Forwarding
					chapter). Once you have registered the number, the machine will
		3	Paging		automatically turn to “FAX FWD:ON” mode. Then retrieve a Memory
					Status List by entering 9 6 1 to make sure that the Fax Forwarding
		4	FAX FWD NO.
					number you registered is correct in the List.
96		Retrieve Fax			Enter the number of a remote fax machine to receive a report or stored
					fax messages. (See “Retrieving the Memory Status List” and “Retrieving
		1	Memory Status List
					Fax Messages”.)
		2	Retrieve all FAX
		3	Erase FAX in the		If you hear one long beep, you can erase the fax message from the
			memory		memory.
	97 Check the receiving status				You can check whether your fax machine has received any Document or
		1	Document		Voice messages. If yes, you will hear one long beep. If no, you will hear
					three short beeps.
		2	Voice
98		Change Answer Mode			If you hear one long beep, you can change the answer mode. If you hear
		1	TAD		three short beeps, you cannot change it. (Example: There is no TAD
					MSG when you want to change to TAD mode.)
		2	F/T
		3	FAX
90		Exit			After a long beep, you can exit remote control.