Airlink101 AP411W user manual

Page 17

Fragment Length: The fragmentation threshold, which is specified in bytes, determines whether packets will be fragmented. Packets exceeding the 2346 byte setting will be fragmented before transmission. 2346 is the default setting.

RTS Length: This value should remain at its default setting of 2,346. If you encounter inconsistent data flow, only minor modifications to the value range between 256 and 2,346 are recommended.

Transmit Power: Choose to transmit in full, half (-3dB), quarter (-6dB), eighth (-9dB), or minimum power.

Super G Mode: Super G is a group of performance enhancement features that increase end user application throughput in an 802.11g network. Super G is backwards compatible to standard 802.11g devices. For top performance, all wireless devices on the network should be Super G capable. Select either Disabled, Super G without Turbo, Super G with Dynamic Turbo, or Super G with Static Turbo.

Note:

„Super G without Turbo: Capable of Packet Bursting, Fast Frames, Compression, and no Turbo mode.

„Super G with Dynamic Turbo: Capable of Packet Bursting, Fast Frames, Compression, and Dynamic Turbo. This setting is backwards compatible with non-Turbo (legacy) devices. Dynamic Turbo mode is only enabled when all devices on the wireless network are configured with Super G with Dynamic Turbo enabled.

„Super G with Static Turbo: Capable of Packet Bursting, Fast Frames, Compression, and Static Turbo. This setting is not backwards compatible with non-Turbo (legacy) devices. Static turbo mode is always on and is only enabled when all the devices on the wireless network are configured with Super G with Static Turbo enabled.

802.11g Only: Disabled/Enabled. If enabled, data throughput will be set at 54 Mbps only.

Radio On/Off: Turns the radio on or off. If set to off, no wireless connection can be established.

Click Apply to save any changes.

17

Image 17
Contents Model # AP411W User’s Manual Table of Contents Introduction Package ContentsConnections Wireless Basics Installation Considerations Connecting the Access Point Ssid default Establishing Wireless ConnectionConfiguring the Access Point Optional Select Internet Protocol TCP/IP and click Properties Click Close Page Page Web Configuration Utility 255.0.0.0 Advanced SetupConfiguration IP Address Configuration Device Information Configuration AP Mode Settings Configuration Wlan Parameter Settings Page Configuration Access Control Settings Configuration Wlan PartitionControl Configuration Security SettingsKey Size WPA Mode Additional WPA settings Radius Server Required Management Administration Management Misc Maintenance Update FirmwareMaintenance Restart System Maintenance Configuration FileStatistics Page Troubleshooting Forgot my encryption key Why does my wireless connection keep dropping?Why can’t I get a wireless connection? Reset Device Management Technical SpecificationsReceiver Sensitivity Technical Support