Airlink101 AP411W user manual Connecting the Access Point

Page 6

Connecting the Access Point

Step 1 Connect one end of a network cable to the Ethernet port of the access point and connect the other end of the cable to the LAN port of a router.

Step 2 Power on the access point by connecting one end of the supplied power adapter to the power jack of the access point and connecting the other end to an electrical outlet.

Step 3 Make sure the Power and LAN lights on the Access point are lit, and the WLAN light is blinking. If not, verify the cables are functional and try the above steps again.

6

Image 6

Contents Model # AP411W User’s Manual Table of Contents Package Contents IntroductionConnections Wireless Basics Installation Considerations Connecting the Access Point Establishing Wireless Connection Configuring the Access Point OptionalSsid default Select Internet Protocol TCP/IP and click Properties Click Close Page Page Web Configuration Utility Advanced Setup Configuration IP Address255.0.0.0 Configuration Device Information Configuration AP Mode Settings Configuration Wlan Parameter Settings Page Configuration Wlan Partition Configuration Access Control SettingsConfiguration Security Settings ControlKey Size WPA Mode Additional WPA settings Radius Server Required Management Administration Maintenance Update Firmware Management MiscMaintenance Configuration File Maintenance Restart SystemStatistics Page Troubleshooting Why does my wireless connection keep dropping? Why can’t I get a wireless connection?Forgot my encryption key Reset Technical Specifications Device ManagementTechnical Support Receiver Sensitivity