Motorola XTNI manual Battery Latchbattery latch Slots

Page 15

Installing the Lithium-Ion (Li-Ion) Battery

Removing the Lithium-Ion (Li-Ion) Battery

battery

latchbattery latch

slots

BATTERIES AND CHARGERS

1.Turn OFF the radio.

2.With the Motorola logo side up on the battery pack, fit the tabs at the bottom of the battery into the slots at the bottom of the radio’s body.

3.Press the top part of the battery towards the radio until a click is heard.

Note: To learn about the Li-Ion Battery Life features, refer to ‘About the Li-Ion Battery’ on page 11.

1.Turn OFF the radio.

2.Push down the battery latch and hold it depressed while removing the battery.

3.Pull the battery away from the radio.

13English

Image 15
Contents Page Page Contents Hands Free without Accessories iVOX30 Contents AccessoriesComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Overview Parts of the RadioRadio Overview Overview RadioModel Frequency Transmit Power Number Antenna Band Battery Features and Charging Options About the Li-Ion BatteryBatteries and Chargers Batteries and Chargers Battery Recycling and DisposalBattery Latchbattery latch Slots Turn OFF the radio, if it is turned on Removing Alkaline BatteriesPower Supply, Adaptors and Drop-in Tray Charger Battery Life Information Installing Spring Action Belt ClipCharging with the Drop-in Tray Single Unit Charger Charging the BatteryCharging a Stand-alone Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Standard Charger LED Indicator Drop-in Tray Charger LED IndicatorsEstimated Charging Time Status LED Status Comments Getting Started Talk Range Receiving a CallGetting Started Radio Status LED Indication Radio LED IndicatorsHANDS-FREE USE/VOX Getting Started With Compatible VOX AccessoriesMicrophone Gain Hands Free without Accessories iVOXSetting VOX Sensitivity Battery SaveEnd of Transmission Tone Roger Beep Tone Reset To Factory DefaultsProgramming Features Programming ModeLearning To Read The Values The Radio Signals You Features Programming Mode Reading your Radios Features ValuesProgramming Features Programming ModeReading Frequencies Values Entering Programming ModeFrequencies Saving Settings Reading Auto-Scan ValuesProgramming Frequencies, Codes and Auto-Scan Programming Mode FAQ Just programmed the value I wanted Example of Programming a Code Example of Programming Auto Scan Other Programming Features ScanNuisance Channel Delete Editing Scan ListCPS Computer Programming Software Call Tones Time-Out TimerBattery Type Setting Bandwidth SelectCloning with a Multi-Unit Charger MUC Programming Features Cloning RadiosPress and release SB1 When ordering the MUCOperating Instructions What to do if cloning fails Cloning using the CPS Computer Programming SoftwareTroubleshooting TroubleshootingMonitoring’ Section on page 24 for further information Light does not come on USE and Care If the radio is submerged in waterUSE and Care Frequency and Code Charts Frequency and Code ChartsChannel Radios PMR 446 Defaults Ctcss CtcssDPL Codes DPL Code Motorola Limited WarrantyWarranty Information What is not Covered by the WarrantyMotorola Limited Warranty Accessories Chargers Page 6871663M06-A