Motorola XTNI manual Removing Alkaline Batteries, Turn OFF the radio, if it is turned on

Page 16

BATTERIES AND CHARGERS

Alkaline battery pack (optional accessory)

Installing Alkaline Battery Pack

Alkaline

Battery

Door

1.Turn OFF the radio, if it is turned on.

2.Remove Li-Ion battery

3.Assemble alkaline battery pack (optional accessory) in the same steps as installing the Li- Ion battery pack.

4.Remove battery door from alkaline battery pack.

5.Slide the 5 AA alkaline batteries into the frame, matching the markings inside the compartment.

Removing Alkaline Batteries

Alkaline

Battery

Door

1.Turn OFF the radio, if it is turned on.

2.Slide the battery latches, on both sides of the battery, downwards.

3.Pull the top of the battery away from the radio’s body, and lift the battery from the radio’s body.

English 14

Image 16

Contents Page Page Contents Hands Free without Accessories iVOX30 Accessories ContentsComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Parts of the Radio Radio OverviewRadio Overview Radio OverviewModel Frequency Transmit Power Number Antenna Band About the Li-Ion Battery Battery Features and Charging OptionsBatteries and Chargers Battery Recycling and Disposal Batteries and ChargersBattery Latchbattery latch Slots Removing Alkaline Batteries Turn OFF the radio, if it is turned onPower Supply, Adaptors and Drop-in Tray Charger Installing Spring Action Belt Clip Battery Life InformationCharging the Battery Charging with the Drop-in Tray Single Unit ChargerCharging a Stand-alone Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Drop-in Tray Charger LED Indicators Standard Charger LED IndicatorEstimated Charging Time Status LED Status Comments Getting Started Receiving a Call Talk RangeGetting Started Radio LED Indicators Radio Status LED IndicationWith Compatible VOX Accessories HANDS-FREE USE/VOX Getting StartedHands Free without Accessories iVOX Setting VOX SensitivityBattery Save Microphone GainReset To Factory Defaults End of Transmission Tone Roger Beep ToneProgramming Mode Programming FeaturesLearning To Read The Values The Radio Signals You Programming Mode Reading your Radios Features Values FeaturesProgramming Mode Programming FeaturesEntering Programming Mode Reading Frequencies ValuesFrequencies Reading Auto-Scan Values Saving SettingsProgramming Frequencies, Codes and Auto-Scan Programming Mode FAQ Just programmed the value I wanted Example of Programming a Code Other Programming Features Scan Example of Programming Auto ScanEditing Scan List Nuisance Channel DeleteCPS Computer Programming Software Time-Out Timer Battery Type SettingBandwidth Select Call TonesProgramming Features Cloning Radios Cloning with a Multi-Unit Charger MUCWhen ordering the MUC Press and release SB1Operating Instructions Cloning using the CPS Computer Programming Software What to do if cloning failsTroubleshooting TroubleshootingMonitoring’ Section on page 24 for further information Light does not come on If the radio is submerged in water USE and CareUSE and Care Frequency and Code Charts Frequency and Code ChartsChannel Radios PMR 446 Defaults Ctcss CtcssDPL Codes DPL Code Warranty Warranty InformationWhat is not Covered by the Warranty Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M06-A