Motorola XTNI manual Radio LED Indicators, Radio Status LED Indication

Page 29

RADIO LED INDICATORS

	RADIO STATUS	LED INDICATION

	Channel Alias Edit	Red heartbeat

	Channel Busy	Solid orange
	Cloning Mode	Two orange heartbeats

	Cloning In Progress	Solid orange
	Fatal Error at Power up	One green blink, one orange blink, one green blink, then repeat for
	Fatal Error at Power up	4 seconds
		4 seconds

	Low Battery	Orange blink
	Low Battery Shutdown	Orange heartbeat

	Monitor	LED is OFF
	Power-Up	Solid red for 2 seconds

	‘Idle’ Programming Mode /	Green heartbeat
	Channel Mode	Green heartbeat
	Channel Mode

	Scan Mode	Red heartbeat)

	Transmit (Tx)/Receive (RX)	Red heartbeat

Note: Channel Alias Edit only applies to Display Models

GETTING STARTED

27

English

Image 29

Contents Page Page Contents Hands Free without Accessories iVOX30 Contents AccessoriesComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Overview Radio OverviewParts of the Radio Overview RadioModel Frequency Transmit Power Number Antenna Band Batteries and Chargers Battery Features and Charging OptionsAbout the Li-Ion Battery Batteries and Chargers Battery Recycling and DisposalBattery Latchbattery latch Slots Turn OFF the radio, if it is turned on Removing Alkaline BatteriesPower Supply, Adaptors and Drop-in Tray Charger Battery Life Information Installing Spring Action Belt ClipCharging with the Drop-in Tray Single Unit Charger Charging the BatteryCharging a Stand-alone Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Standard Charger LED Indicator Drop-in Tray Charger LED IndicatorsEstimated Charging Time Status LED Status Comments Getting Started Talk Range Receiving a CallGetting Started Radio Status LED Indication Radio LED IndicatorsHANDS-FREE USE/VOX Getting Started With Compatible VOX AccessoriesSetting VOX Sensitivity Hands Free without Accessories iVOXBattery Save Microphone GainEnd of Transmission Tone Roger Beep Tone Reset To Factory DefaultsLearning To Read The Values The Radio Signals You Programming FeaturesProgramming Mode Features Programming Mode Reading your Radios Features ValuesProgramming Features Programming ModeReading Frequencies Values Entering Programming ModeFrequencies Programming Frequencies, Codes and Auto-Scan Saving SettingsReading Auto-Scan Values Programming Mode FAQ Just programmed the value I wanted Example of Programming a Code Example of Programming Auto Scan Other Programming Features ScanNuisance Channel Delete Editing Scan ListCPS Computer Programming Software Battery Type Setting Time-Out TimerBandwidth Select Call TonesCloning with a Multi-Unit Charger MUC Programming Features Cloning RadiosPress and release SB1 When ordering the MUCOperating Instructions What to do if cloning fails Cloning using the CPS Computer Programming SoftwareTroubleshooting TroubleshootingMonitoring’ Section on page 24 for further information Light does not come on USE and Care USE and CareIf the radio is submerged in water Channel Radios PMR 446 Defaults Frequency and Code ChartsFrequency and Code Charts Ctcss CtcssDPL Codes DPL Code Warranty Information WarrantyWhat is not Covered by the Warranty Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M06-A