Motorola XTNI manual HANDS-FREE USE/VOX Getting Started, With Compatible VOX Accessories

Page 30

HANDS-FREE USE/VOX

GETTING STARTED

Motorola XTNi™ radios can operate hands- free (VOX) when used with compatible VOX accessories. A short delay occurs between talking and the radio transmission.

With Compatible VOX Accessories

The default factory setting for VOX sensitivity level is OFF (level ‘0’). Before using VOX,

English 28

usethe CPS (Computer Programming Software) to make sure the VOX level is set to a level different from "0". Then, perform the following steps:

1.Turn radio OFF.

2.Open accessory cover.

3.Insert plug of audio accessory firmly into accessory port.

4.Turn radio ON. Radio LED will blink double red

5.Lower radio volume BEFORE placing accessory near ear.

6.To transmit, speak into accessory microphone and to receive, stop talking.

7.VOX can be temporarily disabled by pressing the PTT button or by removing the audio accessory.

Note: To order accessories, contact your Motorola dealer.

Image 30

Contents Page Page Contents Hands Free without Accessories iVOX30 Accessories ContentsComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Overview Parts of the RadioRadio Overview Radio OverviewModel Frequency Transmit Power Number Antenna Band Battery Features and Charging Options About the Li-Ion BatteryBatteries and Chargers Battery Recycling and Disposal Batteries and ChargersBattery Latchbattery latch Slots Removing Alkaline Batteries Turn OFF the radio, if it is turned onPower Supply, Adaptors and Drop-in Tray Charger Installing Spring Action Belt Clip Battery Life InformationCharging the Battery Charging with the Drop-in Tray Single Unit ChargerCharging a Stand-alone Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Drop-in Tray Charger LED Indicators Standard Charger LED IndicatorEstimated Charging Time Status LED Status Comments Getting Started Receiving a Call Talk RangeGetting Started Radio LED Indicators Radio Status LED IndicationWith Compatible VOX Accessories HANDS-FREE USE/VOX Getting StartedBattery Save Hands Free without Accessories iVOXSetting VOX Sensitivity Microphone GainReset To Factory Defaults End of Transmission Tone Roger Beep ToneProgramming Features Programming ModeLearning To Read The Values The Radio Signals You Programming Mode Reading your Radios Features Values FeaturesProgramming Mode Programming FeaturesEntering Programming Mode Reading Frequencies ValuesFrequencies Saving Settings Reading Auto-Scan ValuesProgramming Frequencies, Codes and Auto-Scan Programming Mode FAQ Just programmed the value I wanted Example of Programming a Code Other Programming Features Scan Example of Programming Auto ScanEditing Scan List Nuisance Channel DeleteCPS Computer Programming Software Bandwidth Select Time-Out TimerBattery Type Setting Call TonesProgramming Features Cloning Radios Cloning with a Multi-Unit Charger MUCWhen ordering the MUC Press and release SB1Operating Instructions Cloning using the CPS Computer Programming Software What to do if cloning failsTroubleshooting TroubleshootingMonitoring’ Section on page 24 for further information Light does not come on USE and Care If the radio is submerged in waterUSE and Care Frequency and Code Charts Frequency and Code ChartsChannel Radios PMR 446 Defaults Ctcss CtcssDPL Codes DPL Code What is not Covered by the Warranty WarrantyWarranty Information Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M06-A