Motorola XTNI manual Reset To Factory Defaults, End of Transmission Tone Roger Beep Tone

Page 32

GETTING STARTED

seconds while powering up the radio until you hear a quick series of beeps. To have a slightly better attack time, set Battery Save feature to OFF so that the radio is always ready to transmit or receive without any delays.

Note: Battery Save feature is set to ON by default

Reset To Factory Defaults

Reset To Factory Defaults will set back all radio features to the original factory default settings. To do so press PTT, SB2 and SB1 simultaneously while turning ON the radio until you hear a high tone chirp beep.

End of Transmission Tone (Roger Beep Tone)

Short press the SB1 button while turning ON the radio to enable/disable End of Transmission Tone.

Note: By default, this feature is OFF.

English 30

Image 32

Contents Page Page Contents Hands Free without Accessories iVOX30 Accessories ContentsComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Overview Radio OverviewParts of the Radio Radio OverviewModel Frequency Transmit Power Number Antenna Band Batteries and Chargers Battery Features and Charging OptionsAbout the Li-Ion Battery Battery Recycling and Disposal Batteries and ChargersBattery Latchbattery latch Slots Removing Alkaline Batteries Turn OFF the radio, if it is turned onPower Supply, Adaptors and Drop-in Tray Charger Installing Spring Action Belt Clip Battery Life InformationCharging the Battery Charging with the Drop-in Tray Single Unit ChargerCharging a Stand-alone Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Drop-in Tray Charger LED Indicators Standard Charger LED IndicatorEstimated Charging Time Status LED Status Comments Getting Started Receiving a Call Talk RangeGetting Started Radio LED Indicators Radio Status LED IndicationWith Compatible VOX Accessories HANDS-FREE USE/VOX Getting StartedHands Free without Accessories iVOX Setting VOX SensitivityBattery Save Microphone GainReset To Factory Defaults End of Transmission Tone Roger Beep ToneLearning To Read The Values The Radio Signals You Programming FeaturesProgramming Mode Programming Mode Reading your Radios Features Values FeaturesProgramming Mode Programming FeaturesEntering Programming Mode Reading Frequencies ValuesFrequencies Programming Frequencies, Codes and Auto-Scan Saving SettingsReading Auto-Scan Values Programming Mode FAQ Just programmed the value I wanted Example of Programming a Code Other Programming Features Scan Example of Programming Auto ScanEditing Scan List Nuisance Channel DeleteCPS Computer Programming Software Time-Out Timer Battery Type SettingBandwidth Select Call TonesProgramming Features Cloning Radios Cloning with a Multi-Unit Charger MUCWhen ordering the MUC Press and release SB1Operating Instructions Cloning using the CPS Computer Programming Software What to do if cloning failsTroubleshooting TroubleshootingMonitoring’ Section on page 24 for further information Light does not come on USE and Care USE and CareIf the radio is submerged in water Channel Radios PMR 446 Defaults Frequency and Code ChartsFrequency and Code Charts Ctcss CtcssDPL Codes DPL Code Warranty Warranty InformationWhat is not Covered by the Warranty Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M06-A