Abocom None user manual 802.1x tab

Page 18

Shared: Shared key is when both the sender and the recipient share a secret key.

LEAP: Light Extensible Authentication Protocol. It is an EAP authentication type used primarily in Cisco Aironet WLANs. It encrypts data transmissions using dynamically generated WEP keys, and supports mutual authentication (only with CCX mode enabled.)

WPA/ WPA-PSK/ WPA2/ WPA2-PSK: WPA or WPA-PSK authentications offer two encryption methods, TKIP and AES. For WPA-PSK, select the type of algorithm TKIP or AES and then enter a WPA Shared Key of 8-64 characters in the WPA Pre-shared Key field.

Encryption Type: For Open and Shared authentication mode, the selection of encryption type are None and WEP. For WPA, WPA2, WPA-PSKand WPA2-PSKauthentication mode, the encryption type supports both TKIP and AES.

WPA Pre-shared Key: This is the shared secret key between AP and STA. For WPA-PSK and WPA2-PSK authentication mode, this field must be filled with character longer than 8 and less than 64 lengths.

WEP Key: Only valid when using WEP encryption algorithm. The key must match with the AP’s key. There are four formats to enter the keys.

ASCII (64 bits): 5 ASCII characters (case sensitivity).

ASCII (128 bits): 13 ASCII characters (case sensitivity).

Hexadecimal (64 bits): 10 Hex characters (0~9, a~f).

Hexadecimal (128 bits): 26 Hex characters (0~9, a~f).

Show Password: Check this box to show the passwords that have been entered.

802.1x Setting: When users use radius server to authenticate client certificate for WPA authentication mode (WPA authentication do not support EAP Method- MD5-Challenge).

802.1x tab:

- 14 -

Image 18
Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Federal Communication Commission Interference Statement Country Code StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Features Chapter IntroductionChapter Installation Install the SoftwarePage Install the Hardware Verification For Windows Vista Page Install the Hardware Network Connection IP AddressUtility Configuration Profile Station ModeNetwork Type Authentication Profile TabSystem Configuration tab Authentication and Security tab Lowest802.1x tab EAP Method Tunnel AuthenticationID\PASSWORD tab EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token CardClient Certification tab Server Certification tabNetwork Network TabAccess Point AP Information GeneralLink Status 802.11nLink Status Tab Advanced Advanced TabStatistics TransmitWMM/ QoS Receive StatisticsMAC Address Timeout Value Apply Tear Down WMM Enable WMM- Power Save EnableDirect Link Setup Enable WMM/QoS TabWPS AP List Rescan Information PIN Code Config Mode Detail WPS TabConnect Rotate Disconnect Delete Radio On/OffExport Profile WPS Associate IE WPS Probe IE Auto Progress Bar Status BarUtility Menu List AboutConfig Soft AP modeConfig Channel Wireless Mode Use Mac Address Security SettingBeacon ms TX Power Idle time60-3600s Access Control Access Control MAC TableMAC Table Power Saving Mode StatusEvent Log Event LogTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Wireless mode Enable TX Burst Enable TCP Window Size Fast Roaming at ApplyReset Counter Click this button to reset counters to zero Transmit Statistics TabReceive Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect Rotate Disconnect WPS Associate IEWPS Probe IE Progress Bar Status Bar Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Among wireless No forwardingClients Hide Ssid Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation