Abocom None Soft AP mode, Config, Channel Wireless Mode Use Mac Address Security Setting

Page 33

Soft AP mode

Config

Config

SSID

Channel

Wireless Mode

Use Mac Address

Security Setting

AP name of user type. Users also can click Use Mac Address button to display it.

Manually force the AP using the channel. (The system default is CH 1.)

Here supports 2.4G (included 802.11b/g/n) wireless mode. (The system default is 2.4G.)

Click this button to replace SSID by MAC address.

Authentication mode and encryption algorithm used within the AP. (The system default is no authentication and encryption.)

- 29 -

Image 33

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software Chapter InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Network Type Authentication Station ModeProfile Profile TabSystem Configuration tab Lowest Authentication and Security tab802.1x tab ID\PASSWORD tab Tunnel AuthenticationEAP Method EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token CardServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoSDirect Link Setup Enable WMM Enable WMM- Power Save EnableMAC Address Timeout Value Apply Tear Down WMM/QoS TabWPS Tab WPS AP List Rescan Information PIN Code Config Mode Detail Connect Rotate Disconnect Export Profile Radio On/OffDelete WPS Associate IE WPS Probe IE Auto Progress Bar Status BarAbout Utility Menu ListConfig Soft AP modeConfig Channel Wireless Mode Use Mac Address Security SettingBeacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusMAC Table Event LogTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstReset Counter Click this button to reset counters to zero Transmit Statistics TabReceive Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect Rotate Disconnect WPS Associate IEWPS Probe IE Progress Bar Status Bar Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Among wireless No forwardingClients Hide Ssid Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation