Abocom None user manual Access Control

Page 35

No forwarding among wireless clients

Hide SSID

Allow BW 40MHz

Tx BURST

Default

Apply

No beacon among wireless client, clients can share information each other. (The system default is no forwarding.)

Do not display AP name. (System default is disabled.)

Click to disable this function. (System default is enabled.)

This function enables the adapter to deliver better throughput, enable this function the link speed will up to 300Mbps, disable this function the link speed will up to 150Mbps only.

Note: This function depends on the capability of device. Here supports link speed up to 150Mbps only, DO NOT support link speed up to 300Mbps.

This function enables the adapter to deliver better throughput during a period, it only takes effect when connecting with the AP that supports this function. (Default setting is enabled.)

Use the system default value.

Click to apply the above settings.

Access Control

- 31 -

Image 35

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software Chapter InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Profile Tab Station ModeNetwork Type Authentication ProfileSystem Configuration tab Lowest Authentication and Security tab802.1x tab EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token Card Tunnel AuthenticationID\PASSWORD tab EAP MethodServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoSWMM/QoS Tab WMM Enable WMM- Power Save EnableDirect Link Setup Enable MAC Address Timeout Value Apply Tear DownWPS Tab WPS AP List Rescan Information PIN Code Config Mode DetailConnect Rotate Disconnect WPS Associate IE WPS Probe IE Auto Progress Bar Status Bar Radio On/OffExport Profile DeleteAbout Utility Menu ListChannel Wireless Mode Use Mac Address Security Setting Soft AP modeConfig ConfigBeacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusEvent Log MAC TableTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstReceive Statistics Tab Reset Counter Click this button to reset counters to zeroTransmit Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Probe IE Progress Bar Status Bar Rotate DisconnectWPS Associate IE Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Clients Hide Ssid Among wirelessNo forwarding Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation