Abocom None user manual Link Status, 802.11n

Page 23

CCX

802.11n

Selected Registrar: Indicate if the user has recently activated a Registrar to add an Enrollee. The values are "TRUE" and "FALSE"

State: The current configuration state on AP. The values are "Unconfigured" and "Configured.”

Version: WPS specified version.

AP Setup Locked: Indicate if AP has entered a setup locked state.

UUID-E: The universally unique identifier (UUID) element generated by the Enrollee. There is a value. It is 16 bytes.

RF Bands: Indicate all RF bands available on the AP. A dual-band AP must provide it. The values are "2.4GHz.”

Close: Click this button to exit the information screen.

CCX information contains CCKM, Cmic and Ckip information. Close: Click this button to exit the information screen.

This tab will show up if the selected access point supports 11n mode. Here shows the connected access point 802.11n related information.

Link Status

Click the triangle button at the right down corner of the windows to expand the link status. The link

status page displays the detail information of current connection.

Click this button to show the information of Status Section.

Click this button to hide the information of Status Section.

- 19 -

Image 23

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software Chapter InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Profile Tab Station ModeNetwork Type Authentication ProfileSystem Configuration tab Lowest Authentication and Security tab802.1x tab EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token Card Tunnel AuthenticationID\PASSWORD tab EAP MethodServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoSWMM/QoS Tab WMM Enable WMM- Power Save EnableDirect Link Setup Enable MAC Address Timeout Value Apply Tear DownWPS Tab WPS AP List Rescan Information PIN Code Config Mode DetailConnect Rotate Disconnect WPS Associate IE WPS Probe IE Auto Progress Bar Status Bar Radio On/OffExport Profile DeleteAbout Utility Menu ListChannel Wireless Mode Use Mac Address Security Setting Soft AP modeConfig ConfigBeacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusEvent Log MAC TableTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstReceive Statistics Tab Reset Counter Click this button to reset counters to zeroTransmit Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Probe IE Progress Bar Status Bar Rotate DisconnectWPS Associate IE Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Clients Hide Ssid Among wirelessNo forwarding Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation