Abocom None user manual Access Point AP Information, General

Add to Profile	Select an item (SSID) on the list and then click to add it into the profile list.
Connect	Select an item (SSID) on the list and then click to make a connection.

Access Point (AP) Information

Double click on the intended AP to see AP's detail information that divides into four parts. They are

General, WPS, CCX and 802.11n information. The introduction is as following:

General

WPS

General information contain AP's SSID, MAC address, Authentication Type, Encryption Type, Channel, Network Type, Beacon Interval, Signal Strength and Supported Rates.

Close: Click this button to exit the information screen.

WPS information contains Authentication Type, Encryption Type, Config Methods, Device Password ID, Selected Registrar, State, Version, AP Setup Locked, UUID-E and RF Bands.

Authentication Type: There are four types of authentication modes supported by RaConfig. They are Open, Shared, WPA-PSK, WPA securities, WPA2-PSK and WPA2.

Encryption Type: For Open and Shared authentication mode, the selection of encryption type are None and WEP. For WPA, WPA2, WPA-PSK and WPA2-PSK authentication mode, the encryption type supports both TKIP and AES.

Config Methods: Correspond to the methods the AP supports as an Enrollee for adding external Registrars.

Device Password ID: Indicate the method or identifies the specific password that the selected Registrar intends to use.

- 18 -