Abocom None user manual Client Certification tab, Server Certification tab

Page 20

ID/ PASSWORD: Identity and password for server.

•Authentication ID / Password: Identity, password and domain name for server. Only "EAP-FAST" EAP method and "LEAP" authentication can key in domain name. Domain name can be keyed in blank space.

•Tunnel ID / Password: Identity and Password for server.

Show Password: Check this box to show the passwords that have been entered.

OK: Click to save settings and exit this page.

Cancel: Click to call off the settings and exit.

Client Certification tab:

Use Client certificate: Choose to enable server authentication.

OK: Click to save settings and exit this page.

Cancel: Click to call off the settings and exit.

Server Certification tab:

Use certificate chain: Choose use server that issuer of certificates.

Allow intimidate certificates: It must be in the server certificate chain between the server certificate and the server specified in the certificate issuer must be field.

Server name: Enter an authentication sever.

Server name must match: Click to enable or disable this function.

Domain name must end in specified name: Click to enable or disable this function.

OK: Click to save settings and exit this page.

Cancel: Click call off the settings and exit.

- 16 -

Image 20

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Federal Communication Commission Interference Statement Country Code StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Features Chapter IntroductionChapter Installation Install the SoftwarePage Install the Hardware Verification For Windows Vista Page Install the Hardware Network Connection IP AddressUtility Configuration Station Mode Network Type AuthenticationProfile Profile TabSystem Configuration tab Authentication and Security tab Lowest802.1x tab Tunnel Authentication ID\PASSWORD tabEAP Method EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token CardClient Certification tab Server Certification tabNetwork Network TabAccess Point AP Information GeneralLink Status 802.11nLink Status Tab Advanced Advanced TabStatistics TransmitWMM/ QoS Receive StatisticsWMM Enable WMM- Power Save Enable Direct Link Setup EnableMAC Address Timeout Value Apply Tear Down WMM/QoS TabWPS AP List Rescan Information PIN Code Config Mode Detail WPS TabConnect Rotate Disconnect Radio On/Off Export ProfileDelete WPS Associate IE WPS Probe IE Auto Progress Bar Status BarUtility Menu List AboutSoft AP mode ConfigConfig Channel Wireless Mode Use Mac Address Security SettingBeacon ms TX Power Idle time60-3600s Access Control Access Control MAC TablePower Saving Mode Status Event LogMAC Table Event LogTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Wireless mode Enable TX Burst Enable TCP Window Size Fast Roaming at ApplyReceive Statistics Tab Reset Counter Click this button to reset counters to zeroTransmit Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Probe IE Progress Bar Status Bar Rotate DisconnectWPS Associate IE Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Clients Hide Ssid Among wirelessNo forwarding Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation