Abocom None user manual Radio On/Off, Export Profile, Delete

Page 31

Export Profile		Export all credentials to Profile.


Delete		Delete an existing credential. And then select the next credential if exist. If
		there is an empty credential, the driver will select any non-security AP.


PIN		Registrar: Add the AP’s PIN code into the PIN code column, and press the
		device PIN button. It will connect with the AP in two minutes and get IP
		address.
		Enrollee: Input the device’s PIN code into the PIN code column of AP. Start
		AP WPS process and click device PIN button. Then, the device will connect
		to AP in two minutes and get IP address.


PBC		Start to add to AP using PBC (Push Button Configuration) method. Click
		this button to connect the AP which supported WPS function within two
		minutes. Meanwhile, the AP should also click the PBC button
		simultaneously.

Note:

After the users click PIN or PBC, please do not rescan within two minutes of the connection. If users want to stop this setup within the interval, restart PIN/PBC or click "Disconnect" to stop WPS action.

WPS Associate IE

WPS Probe IE

Auto

Progress Bar

Status Bar

Send the association request with WPS IE during WPS setup. It is optional for STA.

Send the probe request with WPS IE during WPS setup. It is optional for STA.

Check this box the device will connect the AP automatically.

Display rate of progress from Start to Connected status. Display currently WPS Status.

Radio On/Off

Click this Radio On/Off button to turn ON or OFF radio function.

This icon shows radio on, click to turn it off.

This icon shows radio off, click to turn it on.

- 27 -

Image 31

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software Chapter InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Profile Tab Station ModeNetwork Type Authentication ProfileSystem Configuration tab Lowest Authentication and Security tab802.1x tab EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token Card Tunnel AuthenticationID\PASSWORD tab EAP MethodServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoS WMM/QoS Tab WMM Enable WMM- Power Save Enable Direct Link Setup Enable MAC Address Timeout Value Apply Tear DownWPS Tab WPS AP List Rescan Information PIN Code Config Mode DetailConnect Rotate Disconnect WPS Associate IE WPS Probe IE Auto Progress Bar Status Bar Radio On/OffExport Profile DeleteAbout Utility Menu ListChannel Wireless Mode Use Mac Address Security Setting Soft AP modeConfig ConfigBeacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusEvent Log MAC TableTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstTransmit Statistics Tab Reset Counter Click this button to reset counters to zeroReceive Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Associate IE Rotate DisconnectWPS Probe IE Progress Bar Status Bar Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s No forwarding Among wirelessClients Hide Ssid Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation