Abocom None Event Log, MAC Table, Power Saving Mode Status, Event Time yy/mm/dd-hhmmss Message

Page 37

MAC Table

MAC Address

AID

Power Saving Mode

Status

The station MAC address of current connection.

Raise value by current connection.

The station of current connect whether it have to support.

The status of current connection.

Event Log

Event Log

Event Time (yy/mm/dd-hh:mm:ss)

Message

Records the event time.

Records all the event messages.

- 33 -

Image 37

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software Chapter InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Network Type Authentication Station ModeProfile Profile TabSystem Configuration tab Lowest Authentication and Security tab802.1x tab ID\PASSWORD tab Tunnel AuthenticationEAP Method EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token CardServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoSDirect Link Setup Enable WMM Enable WMM- Power Save EnableMAC Address Timeout Value Apply Tear Down WMM/QoS TabWPS Tab WPS AP List Rescan Information PIN Code Config Mode DetailConnect Rotate Disconnect Export Profile Radio On/OffDelete WPS Associate IE WPS Probe IE Auto Progress Bar Status BarAbout Utility Menu ListConfig Soft AP modeConfig Channel Wireless Mode Use Mac Address Security Setting Beacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusMAC Table Event LogTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstTransmit Statistics Tab Reset Counter Click this button to reset counters to zeroReceive Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Associate IE Rotate DisconnectWPS Probe IE Progress Bar Status Bar Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s No forwarding Among wirelessClients Hide Ssid Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation