ADTRAN Express XRT manual Dest not Isdn, Destoutoforder

Appendix C. Status Buffer Messages

CID>0 rcvd

Received an incoming call from a third party during negotiations with a far-end BONDING unit on the use of the second Bearer channel.

Connect Timeout

Call attempt does not connect in x amount of time.

Deactivated

No signal (INFO0) between Express XRT and NT1.

DEST NOT ISDN

The number called is not ISDN (warning only).

DEST_OUT_OF_ORDER

The called number is out of order.

Dial

The Express XRT placed a call on either the first or second chan- nel. The number called is displayed following the message.

Disconnect

The call on either the first or second channel was disconnected from the network. The far-end phone number is displayed if available. Ensure flow control setting match on both terminal adapters.

Disconnected

Layer 1 is up (INFO4 received) but no layer 2 or 3 activity. This is the normal state of a EuroISDN switch if no call is active and the switch has not dropped layer 1 (physical layer).

Disconnect Req

Far-end unit disconnected during BONDING negotiation.

DTR not up

Express XRT tried to place a call in a dialing mode that requires DTR to be in an active state, but it is not.

Dump call

The Express XRT could not accept an incoming call because it was already involved in a call.

Dump

An incoming call on either the first or second channel was dis- carded by the Express XRT. The calling number is displayed if available.

76 Express XRT User Guide 61202.153L3-1