3Com 10/100BASE-T4 PCI manual Using Windows

Using Windows 95 3-3

installing the drivers. Table 3-2 provides the procedures to use to access DOS from various operating systems.

Table 3-2 Accessing DOS from Other Operating

Systems

Operating System	Procedure
Windows 95	1 Turn on your computer.
	2	Press [F8] as soon as you see this message:
		Starting Windows 95
	3	Press [7], then press [Enter].
	4	Type install at the DOS command prompt to
		run the 3Com install program.
OS/2	1 Boot your computer from a plain DOS diskette.
	2	Type install at the DOS command prompt to
		run the 3Com install program.
Windows 3.x	1 Exit Windows completely (select File, Exit
		Windows, OK).
	2	Type install at the DOS command prompt to
		run the 3Com install program.

Using Windows 95

If you have Windows 95 running on your computer, you should load the driver from the EtherDisk diskette. Follow these steps:

1After inserting the Fast EtherLink PCI adapter and connecting it to the network, turn on your computer.

Windows 95 will notify you that new hardware has been found and is located in slot number “X.”

2Select the following option when prompted for the driver for your new hardware:

Driver from disk by hardware manufacturer

3Click OK.

4You are prompted to insert the manufacturer’s disk into the drive selected.

a Insert the EtherDisk diskette.