AMX MAX-CSE, MAX-CSD10 manual Sendcommand DECODER,SET Video MPEG2 D1, Start Rtsp Server

NetLinx Programming

MAX-CSD10 Streaming Send_Commands (Cont.)

Command	Description
SET URL	The communication parameters must include: communication protocol, IP
Set the URL parameters for	Address, and port used.
	Syntax:
the current audio/video
stream, when in manual	SEND_COMMAND <DEV>,"'SET URL <protocol> <addr><port>
control mode.
	[<audio port>]'"
	Variables:
	protocol = RTP or UDP.
	address = Address of stream in IPv4 dot notation (ex: X.X.X.X).
	port = Primary port for audio/video transport.
	audio port = Port for audio stream (RTP only).
	Example:
	SEND_COMMAND DECODER,"'SET URL UDP 239.168.42.10 5000'"
	Sets the URL to a multicast session (UDP) where it will use port 5000 at an IP
	Address of 239.168.42.10. Since the protocol is UDP, a second audio port is
	not needed.
	Example 2:
	SEND_COMMAND DECODER,"'SET URL RTP 239.168.42.10 5000
	5002'"
	Sets the URL to an IP Address of 239.168.42.10. Since the protocol is RTP,
	two ports are needed; port 5000 is used for the video stream and port 5002 is
	used for the audio stream.
SET VIDEO	The configuration parameters include: codec and resolution.
Set the configuration	Note: Setting the video configuration during 'play' state has undefined results.
parameters for the video	Syntax:
codec.
	SEND_COMMAND <DEV>,"'SET VIDEO <codec> <res>'"
	Variables:
	codec = MPEG2, or MPEG4.
	res = D1, or SIF, or <width>X<height> (up to a D1 resolution).
	Example:
	SEND_COMMAND DECODER,"'SET VIDEO MPEG2 D1'"
	Sets the video configuration to use a very high quality video stream set at
	MPEG2, with a D1 resolution at constant bit rate of 6000 Kbps.
START RTSP SERVER	Sets the current RTSP server session.
Select an RTSP session.	Syntax:
	SEND_COMMAND <DEV>,"'START RTSP SERVER <position>'"
	Variable:
	position = numeric index (1-10)
	Example:
	SEND_COMMAND DECODER,"'START RTSP SERVER 2'"
	Sets the RTSP server to the server described in position 2 of the RTSP server
	list.
STOP	A stream can also be halted via the browser-based UI pages.
Stop the playback of both the	Syntax:
audio and video stream.	SEND_COMMAND <DEV>,"'STOP'"
	Example:
	SEND_COMMAND DECODER,"'STOP'"

94 MAX-CSE/MAX-CSD10 Operation/Reference Guide