AMX MAX-CSE, MAX-CSD10 manual Setting up a Modero Panel to Receive and Display a Stream

Displaying Stream Content

media content. If the network can only handle a throughput of 4 Mbps from the encoder, it is recommended that you use something less than or equal to the High Quality encoder profile.

To receive and display content via a third-party media player (such as the VLC media player): Verify you are using the latest VLC Player application available at:

http://www.videolan.org/vlc/.

UDP transmission of a stream only requires one instance of the VLC Player to display the combined A/V content.

Note that if you are going to try to stream both audio and video to a target computer as separate streams, you will need to open two separate instances of this same application.

One window will display the video portion of the stream (provided by the Target Port field on the Streaming Profiles page), whereas the second window provides the audio portion of the stream (provided by the Target Audio Port field on the Streaming Profiles page).

Obtain the IP Address of the target computer by using the ipconfig command. This process is described in greater detail later in this section.

Setting up a Modero Panel to Receive and Display a Stream

The MAX-CSE must first be prepared to stream to the target Modero panel prior to creating the necessary TPDesign4 panel pages (later be uploaded to the panel).

Obtaining the IP Address of the Target Panel

1.Press the grey Front Setup Access button for 3 seconds to open the Setup page (FIG. 40).

Connection Status

Red Connection Status icon -

indicates no connection to a Master

Green Connection Status icon -

indicates communication to a Master

FIG. 40 Setup page

2.Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected Setup page and display an on-screen keypad.

3.Enter 1988 into the Keypad’s password field and press Done when finished.

68 MAX-CSE/MAX-CSD10 Operation/Reference Guide