Digi TS 4, TS 2/4 manual Configuring Ports for RealPort Command Line, Example

Configuring Ports for RealPort: Command Line

This section describes how to configure RealPort ports from the command line.

Procedure

Use this procedure to use the command line to configure Dig One/PortServer TS 2/4 for RealPort.

This procedure assumes that you have signed on as root and have or will

•Install RealPort software on each RealPort host. See the appropriate RealPort documentation for more information.

•Properly cabled Dig One/PortServer TS 2/4 ports and devices.

•Set up the devices connected to Dig One/PortServer TS 2/4 ports

1.Configure the RealPort TCP port by entering the following command: set tcp realport=771

2.Configure Dig One/PortServer TS 2/4 ports by entering the following command: set ports range=range dev=rp

where range is the range of ports to which this command applies Example: set ports range=2 dev=rp

Example

In this example, all ports are configured for RealPort.

set tcp realport=771

set ports range=* dev=rp

3-4 Configuring Ports for RealPort: Command Line