Configuring Proxy ARP
This section describes how to configure Digi One/PortServer TS 2/4 for Proxy ARP.
Related Information
See the set forwarding command in the Digi One/PortServer TS Command Reference.
Starting Point
This procedure assumes that you have signed on as root and have or will configure modems, modem scripts, devices, and filters for routes that use serial lines.
Procedure
1.Configure the links over which packets will be routed using a set user command. This command must specify (on the ipaddr field) a specific IP address for the remote system using the Proxy ARP service.
2.Configure Digi One/PortServer TS 2/4 for Proxy ARP by supplying a set forwarding command that specifies the following:
•state=passive
•proxyarp=on
Example
In this example, Digi One/PortServer TS 2/4 provides Proxy ARP services to a remote host.
187.155.24.0
Digi Device
PPP
187.155.24.11
set user name=link1...ipaddr=187.155.24.11
set forwarding state=passive proxyarp=on
Configuring IP Routing |