10.Fasten Part A of the Paper Holder to the Handheld Printer Terminal. Press both ends of Part A to fasten to the Handheld Printer Terminal.
11.Insert the projections on both sides of Part into the grooves of Part B and fasten to the Handheld Printer Terminal with the four screws for the Paper Holder.
12.While spreading apart both ends of Part A ( 1 ), remove Part A from the Handheld Printer Terminal by lifting up Part A until the projections reach the upper edges of the grooves of Part B ( 2 ), and then press on Part C and Part D from the left and right sides ( 3 ). Next, push on both ends of Part A to fasten to the Handheld Printer Terminal.
Remove the Holder
1.Check that the power is off. If the power is on, always make sure to turn it off by pressing the power key.
2.Remove the Paper Holder by following
the reverse procedure for "Attaching the Paper Holder", and then attach the Roll Paper Holder.
•Remove Part C and Part D using an ordinary screwdriver as shown in the illustration.
|
| 2 | 1 |
|
| D | |
|
|
| |
| 1 |
| 3 |
|
|
| |
C |
| 3 |
|
|
|
|