Installing Options
H If the duplex unit is not installed, skip this step and go to step I. If the duplex unit is installed, the plastic edges on each side of the unit must be removed. The edges are held in place by four small posts. Twist the edges to break the posts and re- move them from the unit.
ZAEP290E |
I Slide the bypass tray into the print- er aligning the grooves of the right and left sides of the bypass tray onto the rails inside the holder.
ZAEP300E |
J Use the wrench to attach the by- pass tray to the holder. Fasten the screws in the order shown in the illustration.
K Remove the adhesive tape hold- ing the bypass tray and cable, and attach the connector to the socket on the left bottom side of the back of the printer.
2
ZAEP320E
Note
❒Keep the wrench in the wrench house inside of the front cover. Only one wrench can be kept in the wrench house.
ZAEP541E |
❒After installing all options, print a configuration page to confirm the installation. If the new de- vice is listed in the column of configuration options, then it has been properly installed. For more information, see P.54 “Printing a Configuration Page”.
ZAEP310E
33