Ricoh AP3200 Loading Paper in Bypass Tray Type, Open the bypass tray, Lift the paper guide lever

Loading Paper

Loading Paper in Bypass Tray Type 270

Note

❒Paper sizes supported by the by- pass tray are in the approximate range of 90 - 297 mm (3.54" - 11.69") in width, and 148 - 432 mm (5.83" - 17.00") in length.

❒To specify a custom size with the operation panel, see "Specifying a Custom Paper Size for the Bypass Tray" in the Printer Reference in- cluded as a PDF file on the CD- ROM.

❒If you load a custom or unique pa- per size, set the paper size using the operation panel.

A Open the bypass tray.

ZAEY040E

B Lift the paper guide lever.

ZAEY210E

Note

❒Swing out the extender to sup- port paper sizes longer than A4

short-edge feed (Metric version) or 8 1/2" ⋅ 11" short-edge feed (Inch version).

C Load the paper and adjust the pa-	2
per guides to the sides of the pa-

per.

ZAEY220E

Important

❒Confirm the print side of OHP transparencies. Some OHP transparencies can be printed on only one side.

Note

❒Do not stack paper over the lim- it mark. If you do, skew images or paper misfeeds might occur.

❒When you set a custom size or thick paper in the bypass tray, do not stack paper above the lower limit mark of the bypass tray.

❒To avoid paper multi-feeds, shuffle sheets before setting them in the tray.

❒Load the paper face down onto the tray.

Important

❒ If the paper guides do not match the paper size, skew images or paper misfeeds might occur.

49