Samsung BN68-01416D-00 user manual United Kingdom

Page 54

Wiring the Mains Power Supply Plug (UK Only)

IMPORTANT NOTICE

The mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse is indicated on the pin face of the plug and, if it requires replacing, a fuse approved to BSI1362 of the same rating must be used. Never use the plug with the fuse cover omitted if the cover is detachable. If a replacement fuse cover is required, it must be of the same colour as the pin face of the plug. Replacement covers are available from your dealer.

If the fitted plug is not suitable for the power points in your house or the cable is not long enough to reach a power point, you should obtain a suitable safety approved extension lead or consult your dealer for assistance.

However, if there is no alternative but to cut off the plug, remove the fuse and then safely dispose of the plug. Do NOT connect the plug to a mains socket as there is a risk of shock hazard from the bared flexible cord.

IMPORTANT

The wires in the mains lead are coloured in accordance with the following code:

BLUE - NEUTRAL BROWN - LIVE

As these colours may not correspond to the coloured markings identifying the terminals in your plug, proceed as follows: The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK. The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED.

WARNING:

DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL, WHICH IS MARKED WITH THE LETTER E OR BY THE EARTH SYMBOL , OR COLOURED GREEN OR GREEN AND YELLOW.

Warranty Card

UNITED KINGDOM

This Samsung product is warranted for a period of twelve (12) months from the original date of purchase, against defective materials and workmanship. In the event that warranty service is required, you should return the product to the retailer from whom it was purchased. However, Samsung Authorised Dealers and Authorised Service Centres in other EC Countries will comply with the warranty on the terms issued to purchasers in the country concerned. In case of difficulty, details of our Authorised Service Centres are available from:

Samsung Electronics U.K. Ltd.

Customer Care Centre

PO Box 17243

Edinburgh, EH11 4YB

United Kingdom

Tel: 0845 SAMSUNG (7267864)(UK & Northern Ireland)

Tel: 0818 717 100 (Republic of Ireland Only)

Fax: 0845 650 8080

Web : www.samsung.com

WARRANTY CONDITIONS

1.The warranty is only valid if, when warranty service is required, the warranty card is fully and properly completed and is presented with the original invoice or sales slip or confirmation, and the serial number on the product has not been defaced.

2.Samsung’s obligations are limited to the repair or, at its discretion, replacement of the product or the defective part.

3.Warranty repairs must be carried out by Authorised Samsung Dealers or Authorised Service Centres.

No re-imbursement will be made for repairs carried out by non Samsung Dealers and, any such repair work and damage to the products caused by such repair work will not be covered by this warranty.

4.This product is not considered to be defective in materials nor workmanship by reason that it requires adaptation in order to conform to national or local technical or safety standards in force in any Country other than the one for which the product was originally designed and manufactured.

Image 54
Contents 0818 717 Samsung Contact Samsung WorldwideCountry Customer Care Centre  Web Site BN68-01416D-00User Instructions Contents Checking Parts Using the Stand-BaseFerrite Core Power Cord, S-Video Sold SeparatelyControl Panel Power IndicatorRemote Control Sensor Front or Side PanelInput/Output Specification Connection PanelEXT 1, EXT Side Panel Headphones jackHdmi in 1,2 Supported modes for HDMI/DVI and ComponentViewing the Remote Control Teletext FunctionsViewing the Menus Switching Your Television On and OffInstalling Batteries in the Remote Control Main lead is attached to the rear of the televisionPlug & Play Feature Make sure that the antenna is connected to the TVPress the Enter button If you want to reset this feature … Spain OnlyUsing the Tools Button Viewing External Signal SourcesStoring Channels Automatically Not available in DTV or external input modeEditing Device Names You can give a name to the external source Colour System Auto/PAL/SECAM/NTSC4.43 Channel modeStoring Channels Manually  Sound System BG/DK/I/LAdded Adding / Locking Channels Adding channels  Locking channelsSorting the Stored Channels Assigning Names to ChannelsFine Tuning Channel Reception LNA Low Noise AmplifierPress the or button until you reach the optimal setting Customizing the Picture SettingsEasy Setting Changing the Picture StandardConfiguring Detailed Settings on the Picture Picture Options Side to side Horizontal Dot. The Time setting allows Using this function, you can adjust the Colour and Tint toBar Patterns, without using an additional Blue Filter − Pixel Shift Using this function, you can minutely moveResetting the Picture Settings to the Factory Defaults You can set detailed picture settingsOptimum condition for pixel shift TV/Ext/AV/Component Sound Features Selecting the Sound Mode depending on the model Connecting Headphones Sold separatelyThis function is only available in Analog TV mode Press the or button to select Sleep Timer Time FeaturesPress the Tools button on the remote control  Timer 1 / Timer 2 / Timer Light Effect Off/In Standby/In Watching TV/Always Press the or button to select Setup, then press Language  Melody Off/Low/Medium/HighSetting up Your PC Software Based on Windows XP Input Mode PC Sub InputHDMI/DVI Input Image Reset Setting the PC Auto Adjustment Coarse/FinePreviewing the DTV Menu System Audio Language Displaying Programme InformationLanguage Primary Audio Language − Channel Operating the DTV MenuDigital Channel − Frequency Preview  AddChannel list  DeleteRefer to Channel ListChannels and all channels Next channel listDefault Guide Scheduled ListAll Channels and Favorite Channels Language The Audio Language, Subtitle Language, PreferenceLanguage, Subtitle Language, and the Teletext Teletext Language of the Language menu show aYou can set the translucency of the on-screen menu This menu consists of 11 sub-menusMenu Transparency Change PIN / Parental LockDigital Text Subtitle button on the remote controlActivates even though Hard of hearing mode is  Press the or button to select required menuYou can get information about the signal status − Installing the CI Card− Signal Information Error level / Signal StrengthFactory state What is Anynet+? Connecting Anynet+ DevicesTo connect to Home Theatre Meassage Configuring Anynet+ connection... is Setting Up Anynet+Scanning and Switching between Anynet+ Devices Turned OffRecording Check Points before Requesting Service Listening through a ReceiverStore Teletext Feature depending on the model# cancel SizeContents Wall Mount Kit Specifications Vesa QuantityEntering the menu Wall- mount adjustment Sold separatelyOr button to select Setup, then press the Enter button Remembering the PositionHow to assemble the Stand-Base depending on the model Moving to the remembered positionTroubleshooting Specifications Risk of Electric Shock do not Open United Kingdom This page is intentionally Left blank Correct Disposal of This Product