Color temperature, Input gamma mode, Size

Picture Settings	A submenu of picture control functions including
	Color temperature
	To select the color temperature of the incoming material. Options are
	Warm, Neutral, cold. With a 7200K display device (a typical projector
	or LCD set to neutral) these correspond to nominal settings of
	6500K, 7200K & 9300K respectively. For neutral color temperature
	response, that is, to leave the response of the program material
	unmodified, select Neutral, this is the default setting
	Input gamma mode
	Used to re-map an input gamma to a different output gamma setting.
	Only use this function if the output gamma has also been chosen on
	the Output Settings menu, otherwise leave set to Linear
	Black Level
	Use to select or de-select 7.5IRE black level set-up adjustment.
	Should always be on for HDMI video inputs and should usually be off
	for analog video inputs.
	Input Capture
	Select the amount of overscan.
	Position
	Allows horizontal and vertical adjustment (pan and tilt) of the
	captured active image area within the overall display resolution.
	Note: The range of position adjustment available is limited by the
	characteristics of the signal timings from the image source
	equipment: in some circumstances adjustment may not be possible,
	particularly with HDMI/DVI signals. Significant changes in output
	image position (to correct for projector alignment errors) should be
	effected via the Warp corner-adjustment menu.
	Size
	Allows control of the width and height of the image, used to fine-tune
	the aspect ratio or to adjust to a nonstandard aspect ratio. Can also
	be used to select an adjustable amount of horizontal and vertical
	overscan or underscan.

Picture Settings Menu

Issue 1.0.2

Page 15 of 30

Color temperature

Input gamma mode

Black Level

Input Capture

Position

Size