Calibre UK VANTAGE-HD Connect to, Display device, Connect audio, Output, Connect input, Configure

	Connect to	Connect Vantage-HD SVGA (RGBHV) output or HDMI output to your
1.		display device. If connecting a DVI display device you need to use an
	display device	HDMI to DVI converter which we recommend you locate at the display
		end of the cable.
		Connect Vantage-HD audio Coaxial, Optical or Analog output to audio
		processor, if HDMI audio output is not being used.
	Connect audio	Note: For best audio performance it is recommended that Coaxial or
2.		Optical audio be used, not HDMI audio. Some HDMI sources do not
	output	correctly comply with HDMI specifications which can cause audio
		distortion or loss of audio. If this is experienced, please change to using
		Coaxial or Optical audio, or consult the supplier of that HDMI source
		device.
3.	Connect input	Connect input video and audio signals to Vantage-HD.
		Connect power supply provided with Vantage-HD to Vantage-HD power
		inlet jack.
		THIS POWER SUPPLY CARRIES A LABEL SHOWING THAT ITS DC
4.	Connect Power	OUTPUT IS 5V at 7A. DO NOT CONNECT ANY OTHER POWER
		SUPPLY TO VANTAGE-HD WHICH WILL NOT BE COVERED UNDER
		YOUR PRODUCT WARRANTY
		Connect the Vantage-HD PSU to your mains outlet and turn on the mains
		outlet if it is switched
5.	Configure the	Turn on your display device and select the input channel to which you
	display device	have connected Vantage-HD
6.	Switch on	Turn on Vantage-HD by pressing the Power (bottom right) button on the
	Vantage-HD	front panel, or by pressing the On button on the remote control.
		A new Vantage-HD unit will power up in 640x480 @ 60Hz output mode
		since this should be compatible with all common display devices. If your
	Set Vantage- HD	Vantage-HD has previously been connected it may power up in a
7.		different mode. If this mode is not compatible with your display you can
	output mode
		easily revert to the 640x480 @ 60Hz output mode by simultaneously
		pressing the front panel Input key and OK key (OK is the center key of
		the 5-button navi-key).
		Press the Menu key to bring up the OSD menu. Scroll to the Output
		Settings menu using the top/bottom navi-keys. Go into that menu by
		pressing the right navi-key.
		First choose your type of display by using the up/down navi-keys to scroll
		to the Display menu item (if not already highlighted) and pressing OK (the
		center button of the navi-key). The options which appear are:
8.	Select display	a)	LCD - for direct-view LCD displays
	device type	b)	Plasma - for plasma displays
		c)	Projector - for solid-state (digital) projectors such as DLP,
			LCD, LCOS, DILA or any other type of digital projector
		Choosing the appropriate type of display is important since menu items
		such as temporal noise reduction and how the OSD is generated are pre-
		set to different default values depending on the display type and different
		menu items appear or are hidden such as keystone correction.
Issue 1.0.2			28 March 2006 © Calibre UK Ltd	Page 4 of 30